Other Network Architecture Subjects

Switch#show env allFAN is OKTEMPERATURE is OKTemperature Value: -28 Degree CelsiusTemperature State: GREENYellow Threshold : 56 Degree CelsiusRed Threshold : 66 Degree CelsiusSW PID Serial# Status Sys Pwr PoE Pwr Watts-- ------------------ ----------...

Hi all, I've been looking for an answer to this for the past hour and I can't seem to find one.  I have tried this on two separate computers and got the same results on both computers.  I bought a serial to usb adapter on amazon.  I have connected ...

We have a ME-3600X-24FS-M running 15.2(4)S4, and when I look are the output from the 'show ip dhcp binding' command it appears the right most digit of the 4th octet of the client IP gets truncated, so a 192.168.100.101, shows up as 192.168.100.10, wi...

Hi, I have a pair of Nexus C9372PX configured as vPC peers running version 7.0(3)I1(3). NTP master is configured on both of them. they are configured with 3 NTP servers and can get time updated from them. I am running the NTP master feature and it is...

Hi everyone, I am confused in IPv6, i was research some RFC but certainly i dont knows if i choose the correct. i need to configure some cisco stuff with IPv6 and i want to know what ipv6 use for private and public. Unique local for private (https:/...

Hello all, I hope this message meets you well. I need help updating the license of my company's ASR920 router using putty software. I have the .lic files of the two routers, all I need is help on how to install the licenses on the two routers using p...

Hi! I've been spending so much time trying to gather the correct OID's for my Cisco devices that I've been dreaming about them at night! I need the most critical snmp OIDs to monitor the following: Cisco Switch: sg500-28P Cisco AP Aironet 2700 serie...

Hi, In one of my projects that I am designing (Commercial building/Exhibition Centre) I am proposing Cisco Aironet 2802i as an indoor WAP. The issue that I am facing is that most of Cisco Indoor WAPs come only in white color which does not match my ...

Good day everyone, I was wondering if any on you had experience in configuring Cisco routers with a EPL setup with their ISP. Here's the deal: We have 4 sites, we'll call them Site A, B, C & D. We've installed a Cisco 891F Router (which acts as the D...

Hi, We purchased a 6513E and a small UPS to regulate the power going to it.  We are planning to do a 5800W max operation.  We are not sure about how many power cables needs to be connected and on what kind of circuits. UPS model: SRT5KRMXLT-IEC Pl...

Hi, Yesterday I set up my Cisco 1800 router to work eventually as the main router facing my ISP's cable modem.What I've done is basically the configuration below, but although NAT is working, my Netflix connection (using Apple TV) times out.Since I a...

Interface   Filter-type    Filter-mode    IP-address     Mac-address     Vlan--------- ----------- ----------- --------------- ----------------- ---- Gi1/14          ip                 active            deny-all                                  215 ...