Other Network Architecture Subjects

Hi all. I know this has been discussed in length here on the forums. But I was hoping to get a fresh perspective and perhaps some new developments on the choice between Hybrid and Native. Right now, we are moving to a very standard architecture. Dual...

We are running AS5300 (ver. 12.2) and VPN 3000 Concentrator. We also run RADIUS (FUNK Software) on Windows 2000 server (active directory). We use Windows Domain authentication. We setup users in NT Global Group and allow the authentication through...

This file is over the limit from restart. I saw a solution to this in a previous post. RME is trying to execute some function before ANI is finished discovery......I think this is the problem.....Solution was to set RME so that it does not synch at r...

Thanks,Rich

Is there anybody knows that DB-9 is stands for what. I mean what is DB .

Is there a way to control the signal on a serial interface simular to DDR? I'm working on a network that requires only one user on the network at a time (Half-Duplex). The problem is that when the router comes up, it starts sending packets, this sign...

Have the following and since then the workstations have not been receiving multicast trafic. How do I get multicast going again.Please help!!!(*, xxx.1.1.1), 14:38:37/stopped, RP 10.33.34.61, flags: SJC Incoming interface: Null, RPF nbr 0.0.0.0 Out...

how can I block MSN traffic on my router.

I encountered following error message from cat4003 on the blocked port.%SYS-4-P2_WARN: 1/Traffic from permanent host 00:02:16:8a:79:ff but seen on incorrect port 3/18it's connected to alteon 180e l4 switch.

Is there a way to downgrade or slow down an ethernet host connection running at 10Mb on a Catalyst 65xx, 3750, 3550, etc. to simulate running at 56kb? I don't have mux equipment or WAN cards. We are performing a customer benchmark, and the customer...

What should the command look like to configure compression for a point-to-point frame relay connection on a 3640 router?

Hi:I have two branch ofices connected by E1, but i have a problem; when i send a ping to this one branch office the pinging is the following:Reply from xxx.xxx.xxx.xxx: TTL expired in transit.How can identify what is the problem, because i transmit v...

In order to squeeze every drop of performance from my routers, I think I'd seen where a router can be told not to respond with ICMP Unreachable messages. People scanning our network from the Internet & other scanning behaviour for networks that we d...

I read one Cisco doc that said to use this command on GRE - IPSEC tunnels. http://www.cisco.com/en/US/partner/tech/tk827/tk369/technologies_white_paper09186a00800d6979.shtmlYet the Cisco doc on the command states, "The ip tcp adjust-mss command does ...

Hi all,I get the below message on the console of a 3640router. Anyone knows what this mean ? HW or SWfailure ? I can't get in the ROMMON via Ctrl-Break.ThanksRalfSystem Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT RELEASE SOFTWARE (fc...