Other Network Architecture Subjects

Hello all,I have set up DNS on my cisco3640 for all dial in users with the following commands :ip domain-name mydomain.localip name-server 1.1.1.1when i dial in i can see that my laptop picks up the dns server address but i still have to type the ful...

usually , a samll network is design as follow:internet --->cable modem---> Router A----->(LAN)switch --->All pc/internal server.and there is an additional DMZ link in the Router A as follow:Router A----->(DMZ)external web serverI am new to networki...

Hi,We want to make a isdn connection with a cisco 2500 router using ISDN TA ZyXel Omni TA128.Bu I couldn't success to do it.I have configured serial port as below:Is anubody know the config that what is needed in ZyXEL side and alos router side?!int...

Hi there,I'd like to ask you folks a couple of things:1. Here is the show version output:2501#sh verCisco Internetwork Operating System SoftwareIOS (tm) 3000 Software (IGS-I-L), Version 11.0(5), RELEASE SOFTWARE (fc1)Copyright (c) 1986-1996 by cisco ...

Hi,Is there a way out to get inventory for cisco serial cables attached to the devices.RegardsM

i am having a problem with my 6500 having 2 vlans in browsing network neighborhoodwe are using wins/dns which resides on vlan A. VlanB hosts is experiencing intermittent problem browsing the network even its own vlan. what could be the possible probl...

I have an 827 ADSL router connected to my DSL service provider. Before I had this router, I had a linksys router providing all the NAT and port forwarding functions. Right now I have NAT configured for all my internal computers to translate to my s...

I have a number of 1600 routers which uses isdn to connect to a central router which is also cisco 1600.Lately, few of them times out and status down after about two minutes for no reason. I have checked the obvious like idle timeout and Bri0 interfa...

what's wrong with my 7206?what 's the mean of "Bad CPU ID 00002732"

How do you get 4mb down a single leased line using an X.21 interface, on a 3700 router

on AS5300 with 8 E1 on it, can we configure 7 of them with R2 signaling and 1 with ISDN, can it be done?

I have the following equipment in a 3 floor building:Cat 4506 w/ Sup IV - floor 3Cat 4506 w/ Sup IV - floor 2Cat 4507R w/ Sup IV - floor 1PIX 515 - GW to Internet - floor 1WAN router 2621 - floor 1I was thinking of the following setup:VLAN1 - Managem...

Hi, we have a low-speed leased-line to a customer-site, which is used for remote-administration. Because the traffic from GUI-clients is making telnet/ssh-sessions unworkable, we would like to implement priority-queueing.I can see that the priority-...