Other Network Architecture Subjects

I have two 6509s with several 5505s connected to both of them via GIG links. I also have a two-gig etherchannel between the two 6509s which I want to be used as the best bath between the two. However when I do a show IP route to some remote subnet ...

can anyone give me more information on what this error is telling me?DFM::Chassis::CHASSIS-CA_CORE1::HighBackplaneUtilization is active All I have found is that the threshold as been broken. What can I look at to confirm this is the case.Thank you

Hi people,Can somebody tell why I install a Wic-1t or a Wic-2t in a 1721 router and it does not report de Sx interface? IOS version 12.1(5)T10in Sh runn, I can not see the serial interf.Is the router broken? or Do I need something else?Thanks in adv...

I have a Supervisor (WS-X6K-SUP1A-2GE) with a MSFC, when remove the MSFC from the supervisor and replaced it with a MSFC2, module 15 was not recognized, will this upgrade work? Tried two different MSFC2's and still no luck. Any help on this topic w...

Hello, I´d like to know if Campus Manager IDU 2.0 support the device 11503. I´ve found only information about IDU 3.0 and that IDU support it.I installed Campus Manager 3.2 with IDU 2.0 and the device 11503 appears "device type unknown" and "state un...

Is a Catalyst 3750 able to route IPX ? Could anyone provide me some links ?Thanks in advanceSascha

Hardware: two Cisco 1760 routers.Software on both: IOS 12.2(11)T8.I'm having problems getting multilink ppp to work on a single ISDN BRI connection between a main site and a remote site. My objective is for the full 128K bandwidth to be available as...

Does anyone know if CWW 6.1 will install on an Win XP box? It more than meets the hardware requirements.

We have Cat 4006 switches with inline power tp mods. These will not connect with several realtek integrated chipset ( RTL8139 )based ethernet interfaces on several vendors pc's including HP(Compaq), E-machines, Sony.Has anybody seen this and reache...

Hi,I'm abit confuse abt secondary ip and subinterface... when shd i use sec ip or sub-int? both seems to have the same effect...Thanks-Steven-

Hi,I'm building out a new branch office network for a site. The central office has a 7200 router with two 2-port DS3 line cards. There are ~100 branches, each with a 1721 and a T1 carved out of the ds3's.There are currently no routing protocols imp...

Hi,I have a problem on my VSAT link. Here is the description of my network. We have a VAST antenna with a receiver. The receiver is composed by a Modem Paradis P300 and by a propertary Broadband receiver named Janux. The Janux is used for the downlin...