Other Network Architecture Subjects

How should I set my router inorder to allow 2 network going out thru the router and my router ethernet is connecting back to L3 switch which is doing all the routing.For etc my network 192.168.1.x & 192.168.2.x. The router ethernet is on 192.168.1.x...

HiI can't get dial backup working on a Soho 97.The modem on the AUX port never dials.Debugging reveals the error: Di1 DDR: Cannot place call, no dialer string setRelevant parts of config (sanitized):modemcap entry aopen:MSC=&F1S0=0chat-script dialou...

i have 3 routers( 1601-Area0,2610-Area0 and Area 10,1603-Area 10 and Area 11):Cisco1601#sh ip int briefInterface IP-Address OK? Method Status ProtocolEthernet0 A.B. C.D YES NVRAM up ...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

Hello friends ;We are facing a problem since so many days, it need immediate escalation immediately .i tried to best ,but it was all in vain.I hope you friends will help me out :here is the whole problem analyzed, vtp server :4006(96 ports)(...

At home, I have a cable modem connection to the internet. The modem goes into the WAN of my 806 router. The router gives out 10. nat addresses to my home PC's. I can connect to the internet fine, but when I use the Cisco VPN Client (version 4.0.1)...

Hi,Our main router is a 3640. Up until today it's been working fine, but today I can't telnet into it. I've also tried to console to it but get no login.The router is still running, apart from powering off and on, not sure what else to do.Any ideas?

We dial in to a 3661 router and after authenticating we get a bunch of unreadable characters then we need to hit contol 7 or done on the terminal window.My question is what is this characters and can we take them out. Can we have it automatically clo...

Hello ,We have two separate Networks with different IP address Class , one running in Cisco Platform with 6509 MLS and other running based on 3com Layer 3 Swotch (Core Builder 3500) separated by 1.8 KM distance . We are trying to connect both th...

I installed a WS-X4448-GB-RJ45 module on our 4506 switch.The switch has IOS version 12.1.13EWSuper engine IV (WS-X4515)"show module X " and "show diag online module X" said everything is OK.But the module LED was red.PC connect to this module can pin...

We are saving config on a central management server. On the router we configure tftp-server system:running-config and tftp-server nvram:startup-config.We never had problems until we start a VPN service with IOS 12.2T and 12.3 3DES releases. "tftp-ser...

hay Guys,I have problem with my old switch 2924-xl.Why every compaq I-PAQ connected to my old switch have very slow performance.When I check there is many number of total packets dropped on the fast ethernet but no value on total error.Can somebody b...

Hi.. I wasnt sure which was the best forum to put this in but i will ask here..I have spent many hrs now on this now and i have 2 issues i dont know how to fix...One is ...... How do i edit the config file as i need ot add stuff in the dialer ...

I noticed that most of my 2950T switch deployed reached its memory utilization to seventy percent (70%) or higher (80%) , Is there a need to expand these switch memory? or is it just a normal for the switch. The CPU utilization I noticed is not af...