Pardon my ignorance but could I use an IOS image from a 1700 series router and use it on a 1600 series router? The current 1600 image does not support NAT nor "IP Address Negotiated".TIA,Paul
What is the easiest method to change the discovered IP address in RME 3.3 to the DNS name of the device? I have devices that are discovered before the DNS entries are made, so the devices show up in the inventory with the IP address only. I have be...
Hi,I have a problem runing Telemate.NET software thats include Cisco Voice Manager version 2.1. When a try to create a report of calls of my IP Voice gateway (Cisco 7200) Telemate software agent prompt me that dont have data to process. But i see my ...
I have a question about the Cisco 678 DSL Router...It seems as if I can only have 1 outbound VPN connection at a time. I was wondering if there is a setting I can edit to allow more or anything really, that I can do to enable more outbound VPN'sQWES...
We have had a single DSL 'like' device connected to a 1600 router working very nicely. However, we've been asked by uper management for more bandwidth using the same technology. I know that multiple DSL line can NOT be simply pumped into the 1600 w...
greetingswe have a core of 2 catalyst 4006 switch's and we were experiencing some network anomalies, so we decided to reboot the equipments, one of them does not boot up properly in the post the supervisor modules gives this errors:Power-on-self-test...
CiscoWorks SNMS integrates with WUG, but I can't find any adapters in the CW2k inegration tools to link the full CW2k to WUG.Anyone done or tried to integrate the two? Seems like WUG is an ideal bolt-on to CW2k in those instances where OpenView NNM ...
I'm trying to setup isdn dial backup (from a field office) to an isdn line on our local router (both 3640's).The local router is already being used for remote access (isdn incoming-voice modem) and uses aaa authentication ppp radius for dial-up users...
Does anybody have any useful tips/ experiences etc with compiling Cisco MIBs into TNG Unicentre? I have a customer who is trying to compile the Env MIBs into TNG are they are getting several errors.Any info/ comments etc gratefully received.
Hello experts,I am french (so please excuse my bad english).I want to secure my network (a new one) by learning some MAC address. that is I do nothing during 2 or 3 days and all the MAC adress not in the MAC address table ("show mac adress table") ha...
Hello, I have a Cisco 1720 with a VPN module (see below) and periodically, once a day, the router stops functioning and requires a reload. All techs in the office access a group of production servers through a point to point VPN and the router also ...
Hello,I have a 6509 switch with a SupII module and MSFC. Last night I attempted to establish VLANs and routing on this switch. I logged on to the switch and created the VLANs I needed. I assigned ports to each VLAN. Then I logged on tot he MSFC a...
I have a cluster established which consist of (3) 3548 and (1) 3524. When trying to add another switch (3548) to the cluster I get an error message stating member unreachable. Cluster manager can see the switch and list it's MAC and the type of switc...
I have a Cat 4006 switch. There's a couple of devies plugged into the switch that doesn't register its MAC address. When I do 'sh port mod/port', it states connected. But when I do a "sh cam dyn" on the same mod/port, there's no MAC address listed. A...
