Other Network Architecture Subjects

I'm having routing problems. I am trying to route from my WAN segments to 161.125.3.100 and 161.125.198.5 which is on one segment of my WAN. Each segment has a 2501 with the static route pointing to the main 2501(the config will follow) i can ping ...

Hi all,I had saw some discuss in other forum said that a voice vlan port in 3550 must be a trunk port, and the data traffic vlan should be the native vlan of the trunk. But some body that the port need not be a trunk. Also the doc of 3550 does not sa...

All,I know how to fix this problem but can anyone give me an explination why this happens. (highlighted by *.)LDRD1A01>sh ip eigrp neiIP-EIGRP neighbors for process 69H Address Interface Hold Uptime *SRTT * RTO Q Seq ...

Hi All,I recently encountered a problem with a 3600 series router whereby a while trying to bring up a BRI onterface with the command "no shutdown" my telnet session froze and I could not re-establish a telnet connection, On further investigation I f...

Hello thereI wonder if anyone has experienced the same and if so would mind advising how they solved the problem! This is long, but please read through it, its a very, very strange one.I have recently installed a 2950 onto my network it replaced a 29...

there's a permanent option at the last part of "ip route" command. what's the difference if i add in the permanent or i do not add in? And where do i check whether an ip route has the permanent option?

Per other threads in this forum, I'm trying to use subinterfaces on a 2621's Fast Ethernet ports instead of using multiple secondary IP addresses on the physical port. I can create the subinterfaces, but IOS won't let me assign an IP address to them....

Does anyone know whether the DRAM in Cisco 25xx/26xx can be placed in 3620?Many thanks!

I was trying to do a password recovery on a Cisco 4000 router and when it came to rebooting the router, it then became locked. I can no longer access the router through Hyperterminal. I have also tried to access the router through the network port bu...

I`m trying to configure the mail alerts from the Ciscoworks 2000 server using the blat.exe (built-in mailer program with CW2K) But it is failing install with the following error:"failed to install the registry key for blat"Could somebody advise on u...

I defined in my (in) ACL:access-list 120 permit tcp host 10.10.1.2 eq 1492 host 192.40.31.12 gt 1023but I see the logs and look the detail:Jan 24 16:53:12: %SEC-6-IPACCESSLOGP: list 120 permitted tcp 10.10.1.2(42986) -> 192.40.31.12(1492), 1 packet...

Say I wanted to use a Catalyst 3550-xx-EMI be as an Internet router en lieu of a 72xx or 75xx router. I would be doing BGP routing with a max of 200 routes or so and also need to do QoS rate limiting by IP address and port. Is there any reason I ...

heythere four commands about ip that i don't quiet understand -if someone could explain me even a little i would be very gratefulwhat the command - no ip directed-broadcast mean ?what the command - ip classless mean ?what the command ip subnet-zero m...