Other Network Architecture Subjects

Hi Everybodydoes anyone know what error this is, and how can i resolve this. It comes up every time when i boot up the router, and the version of the IOS is 12.07Tc3640-is-mz.120-7.T.binshould i upgrade the IOS or what?any suggestion would be appreci...

I am having problems with QPM 3.0 not seeing ATM IMA VC's on 26xx/36xx platforms. I do not have problems with ATM IMA on 72xx & 75xx platforms (12.2 & 12.2E. I have tried both IOS 12.2(x) and 12.2(x)T versions. I also tried different PVC configuratio...

I would like to connect to my 6513 thru the PIX. I have 10 VLANs routing thru this switch. My concern is, if I give the 6513 a static assignment thru the PIX I may experience routing issues with my VLANs. Is this a valid concern? I simmply want t...

I have Campus Manager version 3.2.When I add a new cisco catalyst 4006, the MAC address comes in but only via uplink of the seed switch. Then, I reinitialize the database and restore. This is when I get the actual switch with proper ports. Do I ha...

Specifically the problem relates to remotely administering the switches through a clustered firewall (stonegate) which uses a multicast HW address. We were able to manually set the m.a.t for the layer-2 switching so that both nodes receive the traff...

what is the preferred method of failover for LMS? If I wanted to have 2 servers with exactly the same information what method of replication would be best used?Thanks

It seems that my DFM (1.2 with IDU 1.2.3) doesn't import devices from the RME (3.4) inventory anymore. (DFMChangeProbe is running). Import works fine for devices in the same DNS domain as the NMS, in the example router1 (which is not in the same doma...

I have several 400x catalysts switches w/2900 switches connected. Is there any reason to configure these connections as trunks, other than CPU utilization? trunk?4003 -------------2924Note: Everything seems fine without a trunk definitio...

I have a succesfull implementation of 760 routers connecting to multiple sites accross ISDN dial ups. I now need to set up access to ISP's through the 760 as an additional route. Is this possible and can anyone give me pointers on how to do the tas...

Please see the config below. (I changed the ASN and the IP addresses so please don't get hung up on that) My goal is to load balance between FA2/0 and FA2/1, and have my default route (network) be both FA2/0 and FA2/1. If either link goes down, (whi...

Has anyone gotten IPX to run over INTERFACE MULTILINK? I've gotten it to work with Virtual-templates & ipx ppp-client loopback, but no success when trying to use INTERFACE MULTILINK.

I have a setup with the following:s0 <- 1720 -> fa0 -> 5 port basic switch <- e0 <- 1720 -> fa0 -> LAN | | | ...