Other Network Architecture Subjects

The bandwidth percentage calculation on a QOS Class-map is not being calculated correctly by cisco router 3845 with ios 15.1(4)M5.For instance take the following config:policy-map QoS-Shape-Level3-100M-Outclass BR002  shape average 90000000  service-...

Hi All,I have a scenario where HP 5900AF-48XGT-4QSFP+ TOR Switch needs to connect to Cisco 6509E aggregation switch over 10G uplinks, could I use 5m 40GE/10GE HP splitter (JG331A) to achieve the scenario ? Does Cisco support HP splitter ?If not, how ...

Hi Guys,Please consider the following example and share your thoughts:In a MQC deployement, consider that there are following two classes defined:Class1: EF marking with priority 20%Class2: AF41 marking with bandwidth 40%All remaining traffic except ...

Hi All,I have configured below point to point link with FR switch in GNS 3.below is the configuration for the senario.R1#sh run int serial 0/0Building configuration...Current configuration : 144 bytes!interface Serial0/0 no ip address encapsulation f...

This is a list of NetFlow best practices that I have compiled that I feel should be considered when exporting flow data.  It is meant for software developers and consumers who are considering the export of flows for network traffic monitoring.  The g...

       Hello!We currently have lots of branches around the world (at about 20) using a class A subnet segmented in many different subnets.The point is that we would like to use Cisco CP (professional) to perform some monitoring on our routers, but on...

My switches is still operating but when i ping the switch, there isn't any reply. Expert please advice.

My company has about 20 employees and is growing quickly. We are moving to a new office in a few months, and I would like to setup the network there to be able to handle the growth.Specifically, I would like to buy a router that can handle around a d...

Hi I need som help.I am getting some switches and i want to buy some sfp modulesI have these fiber cables, can anyone help me with what type of connectors this is.I have attached an image..Thank you!

Hi,does cisco have a specific device as a terminal server or one has to improvise..? what are the ideal point products to use when improvising..?

I'm having trouble with a PPPoE client.The client is a dialer interface linked to a point to point ATM interface using PVC 0/38The PPPoE debugs show the outgoing PADI but the dialer never processes the PADO even though I can see it in the ATM packet ...

Hi to all! Firstly, i would like to explain my situation. My house has 2 floors. My broadband modem is on the 2nd floor. I have an ea 2700 linksys router there, connected to the broadband modem. However, i can't get a good wireless signal on 1st floo...

I want to recieve PPP on serial (or PPPoA  on ATM) and then relay the PPP session as PPPoE  across an Ethernet.I am trying to avoid L2TP because I'm attempting to replicate a working (non-cisco) solution.The secenario I'm trying to emulate requires P...

We just recently installed a Cisco 24GBE PoE 370W switch for one of our clients.  Model number is WS-C2960S-24PS-L. One PoE device (a Miraki MR66 WAP) that is connected to the switch is beyond the 328ft Cat5 cable length limitation (we estimate the c...