I have a Lucent MAX4000 access sever online with Bell South terminating an ISDN PRI. On this box my switch-type is set to NI-2. I want to replace this box with a Cisco AS5350. NI-2 is not one of the options on the 5350 for ISDN Switch-Type. Which...
Does anyone know of a good resource that gives recommended maximum dlsw peer connections for different router platforms? I am specifically looking for the number of DLSW peers I can connect to a 7200 router and keep the router running around 50%. Is ...
hello,I 'ld like to know if it's possible to bridge several IEEE 802.1q VLANS (with a different IP network # for each) over an ISDN line with CISCO2610XM at both end. This is a back-up configuration that'll be awaked manually.thank
Hi AllI need to include the entire 172.16.x.x subnet in the eigrp routing table bar one subnet, this is 172.16.111.0/24. Is there any way with eigrp that I can deny only that one subnet from the routing table rather than put the 172.16.x.x statement ...
anyone who know's what could cause this problem on a C1720term monDec 4 09:27:56.206: IP ARP req filtered src 192.168.1.66 0030.c1d6.b908, dst 192.168.1.126 209c.0800.209c wrong cable, interface FastEthernet0regardsJonas
Hi, i have the following situation a cisco router 805 with no ISO image. i have tried to install the IOS from tiny rom. but the followin command is not workingboot#upload flashupload: failed (0 seconds), "no such file"kindly note that i can not even ...
Hi all,With this kind of config:interface ATM3/0 no ip address no ip route-cache no ip mroute-cache atm clock INTERNAL atm scrambling cell-payload atm framing cbitplcp atm uni-version 3.1 no atm ilmi-keepalive no atm address-registration!interface AT...
Hi there,I have two routers running EBGP and I want to inject a default route from one to another. I have read that the correct way to do this is 0.0.0.0 0.0.0.0 (interface that the static route is on)Trouble is, there is no static route from the rou...
My understanding is that the "Load" factor displayed with the "show interface" command is based on an average value during a floating window time period, which I believe is 5 minutes. I think this window period can be shorten to a much lower value, ...
Cisco only do 3m cables for serial interface to DCE/DTE.I’ve seen some X21 extension cables that would allow us a longer distance between our router and X21 interface. Has anyone used these and are we likely to see any problems if we use them. ( if a...
i have a switch 3548. Actually if i need to define a SPAN session, all the port related to this session has to belong to the same VLAN.If i don't have VLAN defined, all the ports belong for default to the same VLAN?
I have a 6509 with two WS-X6316-GE-TX cards in slots 7 and 9. The question I have is; are there restrictions for the slots in which you can place gigE cards? I am experiencing packet loss of about 30% on all of the devices on the card in slot 9 but ...
All switches are in VTP transparent. Trunks set to "on" with VLANs pruned manually. Everything works fine. Recently, Trunk set to "auto" on one end, VLANs allowed set to 1-1005, none pruned. Only change made is to set VTP Domain Name. There are ...
