Other Network Architecture Subjects

Hello everyone,I have setup two layer 3 switch(3560),now there is a doubt how can i track my interface which is connected to ISP router,if somehow connectivity between L3 switch and router disturb then how traffic will move to another switch..diagram...

So (foolishly) I let the software updater delete Java 6 (which only Apple provides), and I installed Java 7 from java.com. Was running ASDM 6.4.9, all I got was the Java 7 splash box. Updated ASDM to 6.4.9-103, same problem. I can run ASDM in one of ...

Hi All,I have Cisco 2811 Router and few days ago my router doesn't work correctly. I checked config and found config-register waas changed (0xC502).HUV_Murun#sh version Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(9)T7, RELEASE ...

Hello,I have setup a Terminalserver Cisco 1841 + HWIC-8A and need to configure serveral devices a day. But I have a major problem which I can not solve by myself. While bootup a 28xx or 29xx isr router the bootprocess looks fine but then it stops at ...

Hi Guys,I need configure a VPN site-to-site between two offices (Office A e Office B)The Office A (headquarters) have a Router CIsco 5510 and we have approximately 200 employessThe Office B (branch) dont have any cisco Router but we will buy one ( is...

I have two dhcp server running on vlan1, which serving our workstation on vlan2. 10.10.10.51 is our primary and 10.10.10.52 is secondary server. My question is:- Which server would my workstation get the dhcp from? - If the primary server is down, co...

what is the recommended router in a DMVPN design, for a hub/host site.  Looking to determine router (or ASAA) make/model with at least the following the scenario:1 - 15-30 remote sites2 - 30-50 remote sites3 - 50+ remote sitesremote sites use apps th...

HiI'd like to know if I store two configurations on router flash how do I switch between them?

I recently installed a firmware upgrade on my E3000 to firmware version 1.0.04.build 6.  Since the upgrade I am unable to see any of my files on my network computer which is running windows 7.  Before everything was fine and I could stream to my dvd ...

I understand that the NM-1FE Fastethernet modules are not compatible with Cisco 2600 series routers, just the Ethernet 1-E module.  With that being said, are there ANY modules supported by the 2600, 2621 or 2621XM series routers that have fastetherne...

                   i have configured 3 server farms on my ACE Module with 3 VIP , i need to make all servers in one server farm can ping on to the VIP of the onther server farm , so i need your help please ASAP ?!!

Hello every one,we are going to introduce a new office.as we have already running a setup in older one.we have already an ASA 5510 and a RV042 router in old setup.Now i purchased 2 3560 48 port switches with enhence image and a 2611xm router.  we hav...

Hi All,Right Now we are using Cisco switch model c4006.and we are looking to replacement for the same . Below are our requirements.1: Around 120 Ports (100 Mbps)2: Around 30 Ports   (1Giga)3: Layer2/Layer3Can anyone suggest Which is the best model fo...