I am looking to setup a connection between two 1720 routers via an ISDN BRI connection. This connection will be 24x7x365. I am looking for examples of configurations. Do I want to do DDR?Thanks!
CW2K running on Solaris. If the causer account has been compromised or I want to change the password for it, "after the install" what is the proceedure?
I have two 3600 series routers I use for provisioning my DSL customers. I noticed something interesting today and was wondering if any one can explain it. I cannot trace route from either 3600 to a any user's IP, however I can trace from my workstati...
hi team:I m uploading a new IOS in a 7513, but when i Verify the file, i have always the same error %error verifying slaveslot0:rsp-pv-mz.120-21-ST3.bin (Invalid file header CRC)I did some test´s ( Format de slot, I downloaded again the IOS from the ...
use Switch Catalyst 2924 Xl as Switch Commander and Cat 2912 as member switch. Some of my iMac and G3 are hookup to the Cat 2924Xl and work very well, I can see the my IPShare Server and the other computer on the network but when I move some imac (F...
I have a school that is 100% Macs. I am using a Cisco 2600 series router for the LAN. It is routing IP only and also running NAT internet services. My question is should appletalk routing be on in my router and also would creating multiple zones h...
I have two routers, both are ABR's Area 0 is defined as:network 172.16.1.0 0.0.0.255 area 0network 172.16.2.0 0.0.0.255 area 0I then want to route networks 172.16.5.0 and 172.16.6.0 in another area such as area 1. What adverse affects would happen ...
I have the need to route 9600bps async data. There are 6 sites that need to pass data to one site. It is not a dial connection, meaning that the connection needs to be up at all times. I seem to recall being able to route via the AUX port, but am not...
I am looking into the utilization of individual links within a 4 port etherchannel group that is used as a trunk on a Cat 5500. I want to understand the output of the command "show channel traffic". In looking at the output I see a percentage of traf...
When mapping an ATM PVC through an 8510 E3 card, the routers at each end see input CRC errors. Although the Switch does not see any errors. The only way to resolve this is to configure the mapping as a PVP. Has anyone else experienced this problem ...
Hello,I have tried unsuccesfully to tftp boot a Catalyst 6500 MSFC2, running hybrid code (i.e. Catos on the Supervisor and IOS on the MSFC). I have tried boot tftp://1.2.3.4/imagename.bin from rommon, and boot system tftp from the configuration, but...
Dea ALL,I have CW2K integrated with HP OpenView NNM ver 6.2 on the sam Solaris 7 M/C, the OpenView do the network discover and CW2K imports the discovered cisco devices from it, CW2K does not do any discovery process.With the HP is doing the discover...
Hi All,Could you please tell me what's the meaning of cisco's proprietary Totally Stub Area? My understand is other vendors' router can't put into the Totally Stub Area whoes ABR is cisco router. Am I right? But from LSA view in Totally Stub Area you...
