Other Network Architecture Subjects

When I am configuring PPP authentication CHAP on the Bri or Dialer interface of a 1721 router I get the following error message.AAA: Warning, authentication list "default" is not defined for PPP.The router accepts the command.I can conifgure aaa for ...

Hello,I have the customer sending some large packages from 1.3M to 30M over the frame-relay subinterface. The link is 64k, with CIR of 32 k. But the load of the link is maybe up to 30k. When the packages are sent, the following message appears on the...

Where can I find a list of the MIBs used on Cisco equip.? Thanks in advance.Jpoulos

If the IOS feature- Private VLAN Edge is already Supported in Catalyst 3500XL Switch? Otherwise, will Cisco realize this IOS feature in future? If someone know this, I'd better you E-mail to zongyh@163.net or zongyh@163.com, Thanks !

I have several 4006's but I noticed one is not running MLS:1 2 WS-X4013 JAB04420LWS Hw : 1.2 Gsp: 5.5(1.0) Nmp: 5.5(1)(enable) sho mlsMultilayer switching...

I am presently trying to resolve a dispute with a Telco over billing that revolves around how a BRI interface configured with isdn-send alerting would behave when it recieved a call from a remote router on one channel and it appears to have caused th...

Its a little bit basic question,How to enable router A to ping router C ??A<-----WAN-point-to-point------>B<------WAN-point-to-point------>Cif i am at router B i could ping router A and router CBut i can't ping from router A to router C nor from rout...

Can the PCMCIA flash be used to store both IOS & COS images? Is it the same format? I am looking to store and boot the switch and MFSC image from slot 0.

Hello,I am running version 11.2(8.1)SA6 IOS on a Cisco Catalyst 2924.We are experiencing problems when issuing the 'no shutdown' command on the switch. Although a switch port can be shutdown, the command to enable it again 'no shutdown' fails to bri...

Hi, My question is simple. Does the Pix 501 (the little feller) connect to a software VPN client? If not, does any PIX do this?

Our office was just set up with DSL service through a 678 router from Qwest. Along with our router and DSL service, we received 5 static IP addresses. I have set up the 678 as a DHCP server to automatically assign IP addresses to each of the computer...

I've read a number of Cisco docs, and some of this forums threads.I have a Cisco 2900 XL switch which I want to get bandwidth usage stats from.I need the stats for individual ports (called subinterfaces?).I've read Cisco's doc on this -http://www.cis...

I've been asked to design and implement a portion of an ISP's LAN.The project is about a Housing LAN in which ISP's customers will put their servers.the simplified schema is the following|PIX535|-----|CAT 6513|------|CAT 3550|------------------ ...

Hello,I tried to manage a 2950G-48-EI with RME 3.3 but the device is only recognized as native snmp device.As I looked through the supported SNMP OID's for RME I only found the OID for three 2950 Switches ending with .323 .324 .325But the OID of 2950...

I am curious as the capabilities of receiving syslog messages from a PIX under RME 3.3 and previous versions. Looking at the supported device list, PIX sysloging shows as NOT supported for RME 3.3. However it does show as supported under RME 3.2. Is...