Other Network Architecture Subjects

What cables do I need with nm-8a/s module if I want to use the 2610 router similiar to way the 2509 is used. If I use a the NM-16A, I have to use the CAB-OCTAL-KIT. I don't want to use the NM-16A. The difference between the two is the number of pins.

Hi,We use time-range settings for our routers, and theyuse SNTP to pickup broadcasts from Tardis software.They use UTC time atm , and therefore since the clock change in the Uk this weekend the time-range parameters are an hour out. I have tried usin...

I'm having trouble accessing the VSM through a browser. I've reset the switch to factory settings, configured it with an IP etc, configured an enable password and enabled the http server. I can connect to the http server OK using the enable password,...

Does anyone know if Fast Etherchanneling between Cisco switches (would be a Cat3550) and D-Link switches with port trunking ability works? D-Link doesn't say much about how the do port trunking but it seems to work with my Intel pro/100+ S NICs teame...

Can anyone recommend a version of the 12.2 ios that they are using with a 3640 modem bank. We need to upgrade and I am looking for some feed back on the 12.2 family of ios. Thanks in advance.Jpoulos

I have been faced with the task of combining the bandwidth of two 2MB SHDSL cards in a 1720 Router to obtain an effective 4MB link. Can you use PPP Multilink and if so where can i find some sample configs or articlesOr is there another way to combine...

I'm newby with cisco ISDN. I'm trying to configure a cisco 800 for ISDN, with a static public IP. Does anyone have an example config?

How to restrict Ping and telnet utility from a host to a router?

Hi, does anyone have any good reference material for a Cisco 3620 with a single FE and 2CE1 ports? I want to link two of these back to back over a single megastream line (initially). All the material at Cisco re PRI seems real deep and applies more t...

How do i monitor realtime packet statistics specifically on a fastethernet port on the 3500XL Catalyst? Meaning you can actually see the number of packets increasing eg bad packets etc.

I'm trying to copy a .bin file, from my tftp server, to a 2924 switch in my network.I get the following error when trying to perform a "copy tftp flash"....copy to or from flash not implementedAny thoughts on this?? I've never seen this one before.T...

we have an ADSL service connecting into 2600 Router, the ADSL customers connecting through vpdn, so we have a Virtual-Template interface that contain the configuration of this ADSL service .and when each user connect to the router its virtual access ...

The sample configuration below was taken from Cisco website for a Cisco 827 router. Can I use this same configuration for a Cisco 828 (IOS Version 12.2(1)XE1) router for pure bridging?Cisco827 Pure Bridging Configuration: service timestamps debug ...

I have a 3640 Router with bootstrap vers 11.1 and IOS 12.1(5) and i must update the modemfirmware form a Firmware at 1998 ver2310-6/31998 to the Firmware c3600-2600-analog-fw.1.2.2.bin .In the Upgrate Doku is the notice copy with tftp the Firmware to...

Hello All,I am running Cisco Works for Windows 6.0 on Windows 98 machine (on a test basis).I have installed JRE 1.3 and the JREserver is running too.While opening Cisco View (from the browser of CWW) it gives me following error"Please Grant permissio...