Oops, I first posted my question to the WAN forum, and it looks like this is the correct place. My apologies.We've got a Cisco 678 serving our DSL connection, and a block of public IP's from the ISP. I'd like to be able to route certain public IP's t...
Help, I'm new at this and I'm in a real bind. Does anyone know why interface ethernet1 does not allow external routing for a 1605? Is this totally not allowed or am I just really screwing up? For example I try to use the command ip address negotia...
Hello, if there are 3 offices with 2 network domains, each has one 2611 router with dual wan ports. try to connect them in triangle topology: the ddn link is R1 to R2 to R3 to R1.The purpose is to ensure the 3 offices can communicate with each other ...
i have 3620 which was mistakenly upgraded with an ios meant for a 3640. i have tried to recover it using xmodem. it appears i'll have to delete the old ios image before i can restore the valid one. how can i do this from rommon. thanks
Hi ,Recently I faced a trunk configuration problem for Cat 3548 switch series. The scenario is like this :3 Nos Cat 3548 connected via GBIC ports in a stack mode2 servers connect to the switch stack.Each server has 2 Nos NIC and are connected to the ...
I currently have to convert async ATM Machines at a bank that were originally setup using BSTUN and network enable them to talk IP to a host. I have got it to work using a Black Box Compact terminal server which passes Raw TCP data on a specific por...
We have build up a test environment, where two FE interfaces (in and out) of a packet generator (smartbits) are connected to two corresponding ifs on the 7206. We have set up CBWFQ, based on DSCP-values generated by the packet generator.When we use 1...
I have a 7507 router connected via a 802.1q trunk to a 4006 switch. When I launch Cisco Works 2000 (running on NT) and go into Campus Manager, then to User Tracking or Topology Services, I have immediate HSRP flapping on my 7507. Apparently, the co...
There are two corporation linked by a central router,and there is only one link for the two to get outside of the router with a total bandwidth 4Mbps.How can I split 4Mbps link into two 2Mbps ,so one corporation can access only 2Mbps ,the other also...
I would like to use mrtg to monitor switch, router, and firewall cpu's, memory utilisation. for that I need to know the OID of each of them. I went to cisco site and found many file " .my " ; I don't know how to use them, I would like to browse in th...
We recently added an additonal T1 to our 2621 router. Both T1's are point-to-point to the same ISP. How do you config these two T1 interfaces to aggregate or load-balance our outbound internet traffic? Thanks in advance for any helpWayne
He, I need config VLAN in C2948G-L3, but not funtion.I add command in subinterface and fault. Do you know document with this information ???Topology is: C2948G-L3 (G49) connected with C3524 (G0/1) and (G0/1) to C3524. The problem is what I not...
