Hi , I am writing a little tool to identify and discover various network devices through SNMP agent support on the devices .Cisco Conference call manager runs on a Windows Box and when I try to identify this with MIB II, I get the information of the...
Hello,I have a problem and I would want to know if the problem is the Arrowpoint. The problem is with the telnet sesions, when I have a telnet session open about 30 minutes ( more or less ), the session is disconnected. Also I have the same problem w...
Latest IOS available for GSRs is 12.0(19)S, recently we were hit by a series of severity 1-3 bugs which lead to a mass IOS Upgrade to a higher version on Core-boxes, before ending this project we face new problems related to TDP, CEF, E4 Memory Trace...
Please could anyone tell me the maximum number of devices that can be managed using RME 3.3 (CiscoWorks2000 RWAN) on a Win NT platform? This is purely for inventory purposes and so I do not require the other functions such as software management.Than...
I was just made aware of a bug for the ecmp algorithm on version 11.1. I was making a cost change on the way I advertise my routes to a users network using rip version 2. After i made the changes users were still getting the routes at the same cost. ...
I am trying to configure snmp on my PIX 506 using the commands below without success. Help.Logged in as enable...Step 1 Identify the IP address of the SNMP management station with the snmp-server host command.Pixfirewall#snmp-server host 172.x.x.xWhe...
hi,i have router WAN interface :123.1.4.1 255.255.254.0an another router WAN int :123.1.8.1 255.255.254.0it's impossible to ping each other,but can anyone give me ideal to ping each other
Have 6000, 4000, and 1900 equipment. Need to do end to end statistics. Can't figure for sure from Cisco docs, do I need NAM for true RMON2 for Cat 6000s. Am I going to need similar device for 4000s? Is it impossible for 1900s?
why does the ios release with cat 2950 series switches not support isl trunking? I have checked the documentation and not see any reference to isl only dot1q trunking. In my environment we have multiple 2900,3500 and cat5k switches connected via isl ...
I will start by saying that I am completely new to the Cisco IOS. Now, with that said here is my situation. We are moving offices and upgrading to a full T1 in the process. This requires, of course, a new router and with that new configurations!!! I ...
Can someone give me an indication of the tasks involved, to set up mainframe printing using a CIP card. Currently the organisation I work for has a CIP card connected to a mainframe DLSW+ on the routers and memorex controllers to provide users with m...
I have a 3460 IOS ver 12.2(3) with an internal PRI card (Se1/0) for dial-in/PPP clients. I have a few users who are unable to successfully dial into my 3640 from a BRI. These BRI/MLPPP/PAP clients (win9x/2K) never get past the LCP stages of PPP. fro...
As subject:Does anyone know the Cisco part numbers of serial X-over cables for:- 2600 series router using WIC-2T to 2500 series router (standard DB-60 interface)- 2500 series to 2500 seriesAre there any good guides describing the use and selection of...
I currently have a customer using VOIP, and we continue to have low grade voice. I am wondering what might cause the voice to be garbled, almost like bad cell service
