Other Network Architecture Subjects

I have worked with the cabletron smart switch routers in the past and am used to the way they operate. I would set up vlans and then interfaces associated with those vlans. After that the smart switch would answer routing requests on any port attac...

I have a point to point wan with 3 sites.I have to now join the two remote sites together. Kindof like a partial mesh. Would the best optionbe point to point for all sub interfaces?

I have 2 Cisco 1720 both with Wic-1DSU-T1 cards, at 2 different offices in different cities. I have a T1 connection in placed to connect this 2 Cisco 1720. What do I need to do to configure the 2 1720 together. And make it a network between the 2 off...

I have a WAN with 350 active routes (RIP) at any given point of time. The routers (1600/1700/2500) learn only a maximum of 255 routes out of the available 350 routes. Once I do a clear ip route *, it learns all the 350 routes. However after 3 minutes...

I have 2 2600 routers that connected back to back through 1 V.35 T1 and 1 CT1. I would like to configure MLPPP over two T1 links. Is this doable? If it is. How?

I want to implement a cobalt raq 4 cache appliance in our network. We have a catalyst 6000 switch with 6 vlans. I don't want to configure the raq as traditonal proxy, rather I want to use the transparent mode. Would a class access list be the best ...

(Note: This message was posted as part of the "Ask the Expert" Event on IOS Feature Navigator that took place September 24 to October 5. Feel free to respond to or form discussions around this question)bsyanzCan anyone tell me where I can find out th...

I received these message from a 7206:Oct 3 14:47:04: %ENVM-6-PSLEV: Power Supply 1 state changed from shutdown to normalOct 4 09:52:00: %ENVM-6-PSLEV: Power Supply 1 state changed from shutdown to normalbut no one about the changed from normal to s...

I need to run NAT on my AS5200 to translate some private IPs in the 10.0.1.0 range. From the Cisco docs available, I am not sure what will happen to traffic on my existing ethernet interface if I put the IP nat access lists on it. An example set-up ...

What's the expected behavior when one VLAN crosses over several VTP domains that have spanningtree enabled? I observed that all switches picked the same root switch, but instead of putting a port in blocking, it puts it in "type-inconsis" state.

Has anyone encountered issues in connecting a Cisco router to an Ascend Pipeline router over FR? I am seeing very strange issues. The link comes up, line protocol is up, but I don't seem to be able to get unicast traffic across the link. Broadcast ...

Isdn 801 Cisco Router has been installed at one siteand all the computers on the LAN are able to browse then internet , but after some time ie when the dialer Idle time out has occoured , the line comes down and then when the clients try to connect t...

Hi,Is there other ways to acheive load-balancing and HA withe the above with running BGP and minimum changes on the ISP end.Thax

We have 2611(3 ethernet) on 2 sites,each site have 2 DSL line,one for site to site vpn,one for users policy-routing to connecting to internet.The default route is define to the DSL who doing VPN,site to site vpn working fine.Users can connecting to i...

We have a wireless connection between 2 plants located over 10 miles apart this connection also connects to the internet via a third party. Have simple netgear RO318 routers in place now with allow for internet hookup. I need to connect both networks...