Other Network Architecture Subjects

We have a fairly simple LAN networkk of 90 users. A DSL internet connection with Cisco 678 as the DSU/CSU. I pc with two NICS using a Linux Mandrake to do the NAT'g. One internal subnet. I wanted to create a lab environmnet in a (diff subnet diff d...

NetWare5 server only displaying a small number of SAPed addresses, cisco router sap table looks fine.Cisco router configured for EIGRP only, as I understand it IPX is automatically redistributed to RIP ! should be fine, however NetWare-Technical sugg...

Is there a way to print the configuration file on a 2620 router?Thanks,BIll Baxter

I am working on a design for a customer, who is openeing a new sales office in Austria. I am used to using WIC-1DSU-T1 and WIC-1T's for T1 connectivity. What about for E1's?Thanks,Tim MedleyNetwork ArchitectVoIP GroupiReadyWorld

Allmost all Cisco OSes suports bgp, but not all can handle full routing tables. Which router is best in price/efectivenes and why?

I remember reading at some point that a router could be configured to respond to GNS requests from clients so that IPX traffic could be eliminated from those segments. We have hundreds of server advertisements that get broadcast and although we don'...

If I need a redundant dhcp server on standby router, is there a possibility to configure two routers (in standby) with two dhcp servers to serve a unique segment of lan?

Last year we acquired another company who were an ISP and we have now been asked to connect the two networks. They have their own transit provider and AS number as do we. We are going to create a link between our site and them and use it as a resilie...

If the PTT drops off a full E1 Structured/G.704 circuit with either a X.21 or V.35 interface for me to use---can I plug that directly into a CSU/DSU or Channelized E1 card. Will either of those or both of them take either of those serial interface h...

Recently, I purchased a T-1 connection and a 2610 router with an internal WIC CSU/DSU. The connection was installed and tested. But have yet to get on-line. For soem reason all I can do is ping our suppliers gateway.I can ping there gateway and my in...

I currently have 2 ISPs. My router is configured with BGP. One of the ISPs will be going away soon and we need to transition our internal DNS and hosted sites from one ISP assigned class c block to the secondary ISP and their respective class c blo...

Does anyone know how or can link me to a URL to show me how to properly configure a router to use a modem on an AUX port. I want to use this on my remote sites is my WAN connection goes down. Thanks.Robert.Gile@jdpa.com

I have worked with the cabletron smart switch routers in the past and am used to the way they operate. I would set up vlans and then interfaces associated with those vlans. After that the smart switch would answer routing requests on any port attac...

I have a point to point wan with 3 sites.I have to now join the two remote sites together. Kindof like a partial mesh. Would the best optionbe point to point for all sub interfaces?

I have 2 Cisco 1720 both with Wic-1DSU-T1 cards, at 2 different offices in different cities. I have a T1 connection in placed to connect this 2 Cisco 1720. What do I need to do to configure the 2 1720 together. And make it a network between the 2 off...