Other Network Architecture Subjects

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 

Forum Posts

I need some help. I need to configure 2 3560's to route to each other connected via a MetroE PtP setup with a dot1g tunnel. One side uses a firewall for its gateway, the other needs to use the route on the switch for its default gateway. I would li...

cnelson01 by Level 1
  • 294 Views
  • 1 replies
  • 0 Helpful votes

We are installing sniffers on our network and I wanted to make sure I got the commands right for setting up the monitoring port on out 4506. Are they:Switch(config)# monitor session 1 source interface fastethernet 4/10 (Router Port)Switch(config)# mo...

I'm planning to integrate a new network running MST with a legacy network running PVRST+.There will be a trunk supporting 2 vlan's between the 2 networks, with an additional trunk to be added later supporting the same vlans.Reading up on this, PVRST ...

aacole by Level 5
  • 733 Views
  • 2 replies
  • 0 Helpful votes

I recently followed the password recovery for a catalyst 4506 switch. Everything went ok but when I enter enable mode I don't get the # at the end. When I try to run configure terminal I get the error listed below. I need to know why the # is missing...

Hi,I'm having a silly problem. I have an Exchange server on my LAN, which has an Outlook Web Access page that needs to be seen from the Internet. Local address for it is http:/172.16.0.23/exchange.On router I enter the simpleip nat inside source stat...

Review Cisco Networking for a $25 gift card