Other Network Architecture Subjects

If you have two switches, each with MIST configuration as are identical except for the revision, will MIST consider the two switches in a different domain ? The documentation says that if message digest from the 4096 element table is different then M...

Hi allwhat would be the correct term for my backbone switch in my comms room, would it be a distribution switch ? also if it had vlan routing on would it still be called a distribution switch ?

Hi.I need to make a design for a retail store. Please see the attachment. For illustration purpose on each switch block I had attached 3 access switches. In reality there are many access switches for each switch block. There are different packages in...

Dear All, --------------I have One Router connected to the Internet through MY ISP.-this Router have 2 Interfaces as following :-A.Int F0/0 :-description Interface connected to ISP-ROUTERip ddress 192.168.1.4 255.255.255.0 duplex auto speed auto-----...

I've done bandwidth management with policy-maps. I managed to get it working when I was testing the switches. Now the switches are going to production use and the policys are not working! What can be wrong?Below is the configuration. I've enabled qos...

as i konw that debug condition interface command can analyse one specific interface. when i specified just one interface serial 3/2:5 (it is channelized with x25 line) but bebug result shows all of other interfaces (se 2/0) how can i see just one spe...

Hi all, When setting up a proper 3 layer model, i.e core,distribution,access what do they normally do, would you put the vlans on the distribution and have them routed there, or routed at the core ?

dear sir, i was curious that at the moment we have catalyst 6509 that running cat os. Can i transfer the entire configuration and made it into ios based? any idea? thanks.

Hi all,I have 2 cisco 7609 connected to non-cisco switches which do not support vlan tagging. These non-cisco swicthes are having 6 IP segments (ex: 172.1.1.0/24, 172.1.2.0/24, ...).The design is as below:7609 == 7609V V[core sw]==[core sw]V...

We have a situation that HSRP fails to work due to a partial h/w failure on the active router.What happened is the active router continously getting input error on its Ethernet interface. User traffic fails to be received by this router. However the ...

Hi. I have two Cat6506 (redundant collapsed-core config) configured w/ RPVST+ and connected to this are a series of Cat2950s configured with PVST. My question is, is this a good practice configuration of STP? (running both RPVST+ and PVST on the sam...

Dear all,I have a question, which is probably very easy to answer. I've setup a network with auto qos enabled. between the switches I have a dot1q trunk. Now I want to connect a switch to an access port (so it works more like a hub), does this effect...

I'm in the process of acquiring routers and switches for my lab and would like some advice. 1) Is there an easy way to find out if a version of IOS supports a specific feature set that I'm looking for? I'd like to know, for instance, if HSRP, OSPF,...