Other Network Architecture Subjects

How does the 3750 Enhance behave when it is cascaded to a 3750 Standard?i wanted basicaly to have vlans on my 12 port 3750 enhanced and have the ports on my 3750 standard as access ports for those vlans.I dont know if i need both switches to have enh...

Can I take two 2950 switches and build a vlan trunk between them? I have three vlans on each switch and each vlan is a subnet.

Hi there,I have a customer who has a televantage voip network on a private 192.68.0.0/24 network but has two sites connected via a wireless tower that wants to enable QOS over between the two sites by using a 2621XM router at each end. I've enabled...

Hi,I took the responsibility of a new entrprise network, I noticed that one of the branches router is configured with 192.168.4.1/25(255.255.255.128),but the issue that the branch subnet is 192.168.4.0, 255.255.255.0(all desktops and servers configur...

Hi,I am in need, please, of the syntax to boot the sup of a hybrid 7606 from the flash card. Since my sup2 only has 32mb of mem, I am in need of using a larger flash card to upgrade to a new image. The flash isn't normally accessible from the msfc ...

I have a Cisco 1200 access point configured for peap authentication. I have also created a guest vlan on the access point. The network for Guest Vlan is setup for 10.x.60.128/25. The problem that i have is i dont have full access to our layer 3 de...

Hi allIf I have 2 vlans, how would I join them together, what would be the best and easiest way ?thanksCarl

We are just starting to mess around with this and it seems to be incredibly difficult to get all the stuff configured on diferent boxes . Having to set up QOS on every switch is a pain . We can't use auto qos because we are not using cisco phone...

I want to set up more then two monitor sessions on a 6509 sup720 (IOS = 12.2(18)SXD3) and am running into limitations that are not specified in the documentation. Here is what I have and the error message after I try to add a third session: ENGLAB-65...

Can anyone recommend a course to go on after completing my ICND ?Thanks

Hi,We have several Netware servers running in cluster mode, that share several resources , (mainly file systems). Each of these Netware servers have two NICs, each is connected to a different network switches (Cisco Catalysts.). Then NICS running th...

is it possible to turn off spanning tree on a 3550 ?

hi, i'm not sure if i'm posting this in the right category but here goesi wanna use 802.1x on our network but can't seem to get it to work. i followed all the instruction on the web site. it says authentication failed. i'm pretty sure the radius work...