Other Security Subjects

I have a Cisco 1720 series VPN at one LAN and I have Checkpoint firewall/vpn at branch office. Is there are a policy manager software that can set up a VPN policy between these two devices?Also, can you do access control to certain files on the netwo...

What is the rule of thumb to do packet inspection. Cisco's www site has inspection on the inside interfaces & other publications will have either inside or outside interfaces. They both work but what is the best way?

I have configured my router with the following configuration to block Code Red Worm which I referred to Cisco Security advisor but I still have problem on Code Red Worm coming in to my server.I also have some doubt on should this ACL block procedure ...

Hi,Is there a IDS Director software for Trial/Evaluation Version ???Rgds

Does any cisco products scans incoming traffic for viruses. (Internet gateway scanning)

I can not login the CVM server using any username and passward after I instatlled the CVM server on Windows2000. What will I do .

Hi,I'm trying to install a common DSL/Cable firewall router for peripheral security between LAN and Internet.My approach is to connect outside line to Cisco 1601 router to firewall to LAN.I heared that it could be done if I turn off NAT from Cisco.I'...

I,am trying to configure MPLS on a Cisco 2610 series router with IOS version 12.1.5 T running on it. None of the mpls commands like mpls ip or show mpls interfaces etc work even though cef has been enabled. Does it require any other module to be boug...

Y'know I really do try to research these things on my own before I bring them to y'all, but when the documentation is removed from the website - well, that makes it a bit hard. Specifically, in this case the link at <http://www.cisco.com/univercd/cc...

We are deploying a solution for a Multitentant unit, they will have 8-Mb fiber connection to the net which is connected to a 100Meg TX-FX converter. There will be 2 tenants sharing the access, what devices will I need to get this to work with the fol...

I have a problem with ths config:global (outside) 1 194.94.76.58nat (inside) 1 200.100.0.0 255.255.255.0 0 0static (inside,outside) 194.94.76.60 200.100.0.1 netmask 255.255.255.255 0 0static (inside,outside) 194.94.76.62 200.100.0.4 netmask 255.255.2...

Hi,I have problem to configure PIX to permitconnection from higher to lower security.I use command nat 0 and access-list 101 permitstatement andapplied the access-list to the interface with"access-group 101 in interface inside".But even a ping to the...

Please can you tell me the best way to get into security/Intrussion detection the books are not yet available.Help please I am very keen.thanksOneyor

My organization uses a Safenet/Soft-PK gateway for its VPN. Safenet does not make a MacOS client. Will the Cisco client work with the Safenet gateway?

How to account, in a Cisco ACS, full remote user activities trough a router (ras)i.e.: telnet to an host, http, ftp, ...Thank you