Other Security Subjects

Hi Everyone been a while since i've touched cisco ASA firewalls so could use some advice.  I have an anyconnect vpn user who cannot access a website hosted on a local server. I'm trying to use the packet tracer tool built into asdm. As my source i se...

Hi all, I want to know the difference between K9 & MB in the ASA5512-K9 & ASA5512-MB. I want to upload/activate the AnyConnect License on the ASA. Which serial number should be using to get the activation-key? The serial number is different in the bo...

MS TEAM SESSION BORDER CONTROLLER AND HAIR PINNING TO THE PUBLIC IP FROM Internal devicesHello AllNot sure if this is the correct forum so forgive me as there were to many to choose from.UC is planning on installing 2 SBC on the inside with public ip...

Hello, we are doing PEAP machine only for wired 802.1x, (Policy is set up so if a PC has the cert and is in the AD group it passes) so wondering why we are getting these user auth attempts and so then the switch shows dot1x failed even though the mac...

Hi, I am not sure if this is the right place for the question...I followed some link to generate key, then a CSR. Then I went to the MS cert server and obtained a cert (with the webserver template). Then I imported the cert in my router. GIR02-70#sho...

Hi all, shortly a vFMC and 6 FTDs will be added to a network.The vFMC  is: SF-FMC-VMW-K9 for 25 devices. Smart account will be created soon.My question is, will we need licenses in vFMC in order to manage the new 6 FTDs?Many thanks David  

Hello Team, I have Firepower with version 6.5.0.4 i want to port forward internal server (192.168.21.1) to 218.219.100.46 which is same network range of FW outside interface IP (218.219.100.1 /24).I dont wanna to do port forward to FW outside interfa...

Hi everyone, I am studying for the CCNP Security certification. If I have to configure the rule in access control policy to block some urls and chat and instant messaging ... Which reputation score should I use?In an exercise it proposes 1, 5, 10 or ...

Hi all, i'm trying to change the ssh port on WS-4507R (bootOS : cat4500-entservicesk9-mz.150-2.SG11.bin) but i didn't see command line that it is "ip ssh port" i want to change the port..

VPN Client Notifications gives me the folloiwing error:Initializing the connection...Secure VPN Connection terminated locally by the Client.Reason 440: Driver Failure.Connection terminated on: Feb 14, 2006 13:12:19 Duration: Not connected.I'm ...

I was checking posture in ISE and saw that posture requirement show "operating system", compliance module, and posture type but then again in posture policy they are mentioned again where I also set the requirement which I configured earlier. my ques...