Dear ALL,in order to plan a PIX purchase, I'd like to know what concurrent connections term stand for:inside to outsideoutside to insideboth Regards Alberto Brivio
We have a cisco router 2600 series that is setup as a terminal server to provide reverse telnet out of band console access to a variety of devices hanging off it. We have host names setup so that the admin only has to type the host name to get to the...
Hello,I have a PIX 515 model . Over that i have setup a DMZ where the clients from the DMZ interface telnet to a server inside the PIX. I have complains from the users that connections gets disconnected even when they keep the systems idle for a 10 m...
I will get right to the point..Here's my question.What will happen if you have setup static address translations that fall within the range of the global address pool that that is setup (NAT)?We have defined a pool of addresses that our ISP has made ...
access-list acl-lanf (1) permit tcp host 10.101.5.13 host 10.101.5.11 range 3540 3555Does this allow two way communications between these two devices or do I need to put another entry swapping the IPs?
I have a print server that sits on the 192.168.1.0 network. Anything on this network is able to print to this print server. Anything on my other networks that use IP Inspect are able to print to this print server, when using IOS version 12.3-11T7. ...
We have a PIX 515E Version 6.3(3). I'd like to prevent all inside IPs from sending traffic on port 25 EXCEPT our mail server.Using inside network 10.10.10.xxxOutside IP 63.252.xxx.xxxMail Server 10.10.10.9Would these work?access-list smtp_in permit t...
Hi i have a cisco pix firewall (515E) i ve configured it with : inside 10.1.1.1 255.255.0.0 dmz 192.168.100.1 255.255.255.0 outside 100.100.85.2route outside 0.0.0.0 0.0.0.0 100.100.85.1(internet router)global (dmz) 1 192.168.100.10-192.168.100.20glo...
Hi, I am installing a 3845 router with the security bundle. I come from a checkpoint fw world so this is a bit new to me. Do i just need to setup Access-lists for the firewall code or is there a special way to setup fw rules for cisco routers?Pete
I have VPN tunnel setup between my PIX and a client. I have an access-list applied to my outside port to filter incoming traffic:access-list acl-in permit esp host 213.212.11.9 host 213.1.244.11 access-list acl-in permit udp host 213.212.11.9 host 2...
We have DMVPN setup both hub-spoke and spoke-spoke at my H.O.We want to setup a VPN (point-to-point) with another company, which is having same type of DMVPN setup as of ours, in their VPN box.Is it possible to setup the point-to-point VPN with the o...
Hi guys,i'm going to install 2 blades FWSM on my cat6509 ( i have another 2 still installed ).My problem is syslog server becouse log sent by FWSM are not easy to see and understand ( we have also checkpoint and its logs are more readable ).COuld you...
i have a pix with two interface.one for internal.another for outside.my mail server is located inside.i have config alias command translate mail private ip to public ip.now i can use private ip ,domain name(for example mail.aaa.com)access mail server...
