Other Security Subjects

For a week now, I can´t seem to make them work together, whether I use the C831 EZVPN client or not, in client or network extension mode, etc.The closest I got to make it, was once using the EZVPN client in client mode. Everything seem right then, th...

I'm doing a research on IDS Network sessor. Is there any document like best practise or common implementation where I can find?Thanks in advance.

Can anyone help me with this problem? I have to PIX 515 FW connected back-to-back. The external PIX has only two interfaces and the internal PIX has three interfaces. The external PIX "inside" interface and the internal PIX "outside" interface are co...

After installing the 4FE NIC in the 515e and powering up the firewall, the only ethernet interfaces that show up are 0-2. The 515e originally had a 1FE NIC installed, which I removed and installed the 4FE in its place. Upon running 'sh ver' the MAC a...

I'm trying to FTP using SSL. I am aware that this can not work through the PIX, so I am trying to connect to an FTP server (not maintained by us) over the Internet from a box that is outside our PIX and I still can't connect using SSL/FTP. My quest...

Is there anyway to do this? I need to add an internal route in addition to the gateway.

I'm having a problem setting up a GRE tunnel. I'm just using a basic tunnel config.interface Tunnel195 ip address 172.195.0.2 255.255.255.252 tunnel source Ethernet0/0 tunnel destination 66.82.92.250 The problem is that there is a win 2k system betw...

I have a web server on my DMZ that needs a persistent TCP connection to an internal host. My problem is this connection keeps dropping after an hour or 2. I have my conn timeout set to 8 hours and my xlate timeout set to 3 hours. Is there a way on...

Hi,I am trying to figure out how i can upgrade my VPN clients to latest version (for Concentrator 3015). When i check, i found out that we could send notification to user about the upgrade. Has anyone tried to upgrade the clients using this? How does...

Hi all,I have a TCP service with a public address A.B.C.D port E.I'd like for a range of user defined in an access-list ACL-EXTRA, this range to be redirected through the following ¨private address G.H.I.J port E.For the other range connected to A.B....

We have a small\medium size network. (200-300 users)We wish to replace our existing firewall to a Cisco which allows VPN and VoiceoverIP capabilitiesWhich would be the best Cisco product for us?We're also going to use Cisco for home users, which prod...

I have got strange situation. If I connect to VPN server using home GPRS network VPN service works fine. As soon as the same client (same computer, same Cisco VPN client) goes abroad, there are complains that VPN access does not work. Although I see ...

I loaded SDM on a 1720 router with 12.3 IOS. According to the link below, these routers are supported. I have enough room in flash as we upgraded the boot roms that support larger flash sizes. Problem is when I http to sdm it loads then stops and say...

I am upgrading a customers site with a new 1711. A vendor requires some configuration changes and I would like some assistance before making the changes. The changes are:1. Open bi-directional TCP Port 1723 for PPTP2. Bi-directional GRE (protocol 47)...