Hello,could someone tell me how to configure an asa 5505 for a pppoe connection with german Telekom VDSL?The modem is an Allnet all126as2 and has a synced connection to the DSLAM.IPTV (Entertain) is not needed, only the internet connection should wor...
Forum Posts
Hi, Can we terminate IPSec tunnel on Nexus 7018 chassis?
Pls explain EIGRP FRAME REALY MULTIPOINT SUBINTERFACE WITH FULL MESH TOPOLOGY
ASR - 1000 OSPF routes leaking into BGP when a outage occurs on a upsteam devices Our max number of prefixes is set to 50 by our provide on the PE router, normal operation only 26. When an outage occurs the max number prefixs is exceeding on the PE a...
version 15.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname wireless!boot-start-markerboot system flash c880data-universalk9-mz.154-3.M2.binboot-end-marker!!logging buffe...
Hi, I recently upgraded a pair of 5515-Xs to 9.2.2 for BGP functionality but found that allowas-in doesn't appear to be a valid command. The ASAs are in a data center outside of the country so there's no point to point/MPLS connectivity, just using ...
hello guys i had a problem from my access switch to unifi wifi that i cannot access internet when i connect wifi its saying obtaining ip address most of the time and after getting connected its saying no internet connection but other access switch in...
Does a router treat connected vs non-connected routes differently with RIPv2 from a summarization perspective? I would have said no, but testing says otherwise. Let's assume I've got 3 routers and they are all configured with auto-summary enabled, ...
Hi, I'm trying to configure VRFs for multiple providers and struck with the following. The router R1 is connected to Provider-1, Switch and Provider-2. BGP is running between provider and R1. Provider-1 is in VRF-1 and Provider-2 is in VRF-2. Bu...
I have a ASA 5505 and ASA 5508x. In reference to the attached diagram. I am looking to fail-over a Public IP B to ASA 5508x through ASA5505. The only reason for this configuration is the ASA5505 is with ISP A and with out paying a huge amount we can ...
Resolved! Ping - Timeout - vIOS(Switch)
Buenos días. Intento realizar un ping de 192.168.10.3 a 192.168.30.11, pero no tengo respuesta (192.168.30.11 icmp_seq = 93 timeout).Intento realizar un ping de 192.168.30.3 a 192.168.10.11, pero no tengo respuesta.La PC-2 puede realizar ping a SW2....
Do you recommend using of recursive lookup in a static routing? What is the disadvantage and advantages of it.I have a static route and the next hop is not directly connected to it. The next hop IP address was learned via EIGRP and it is currently in...
Hello, Can anyone advice me how to enable SNMP-AUTH-FAIL message on IOS-XR devices ?
Resolved! 450X support
Hello all ,I wanna to renew cisco support for two Catalyst 4500 WS-C4507R-E & WS-C4507R with lower cost.I know that 4500 is End of sale and support but is there any way.Thanks in advance.
Resolved! OSPF, eBGP and iBGP working together
Hi Team, I have setup wherein I have two CE (A & B) routers connected back to back and running ospf. Both these CE are connected to one PE (A & B ) each and running eBGP with them. I am also running ibgp between the CE's along with ospf. Now I am r...
