¡Saludos a todos!Esta es mi topología:La comunicación entre el Nexus y el Proveedor es por BGP, donde cada equipo tiene un solo ASN pero entre ellos hay un enlace físico por el cual pasan 2 VLAN (301 y 304). En la red que hice de laboratorio, estoy u...
Hello, iam trying to set my router trough the webui by ther is no menu.Any idea where the problem is ? :
I am looking for advice on a multi-path routing solution. We have a large global MPLS network that has ben primary path for along time and is being phased out over the next 18 months. I've built an IPSec route-based VPN tunnels between my home site (...
IP addresses have been cleaned (RFC 1918).We have 5 locations on an MPLS network. All locations advertise their networks through BGP.When we signed up with our phone service, we thought it would make sense to have them on our MPLS network as well. So...
.245, .246 AND .247 ARE OSPF NEIGHBOURS IN AREA 0 AND THEY EXCHANGE ROUTES..5, .10 AND .1 CAN SEE EACH OTHER LOCALLY THROUGH VXLAN SWITCH. THAT SWITCH REPRESENTS VXLAN CONFIG AND ITS OUT OF THE SCOPE.ALL THE SONICWALLS CAN REACH EACH OTHER AND THE 1....
ASA working in IPSec, I am able to access HQ from UNIT No problem. Internet is only allowed on specific IPs which are outside DHCP Scope. When I assign IP for internet, now Internet is working, HQ Network is accessible, but S_EXT (webserver - 10.10.1...
This is getting really frustrating. Every time I try to ask this question it's tacked on to a different thread about a different question that is already answered, so no one answers. I am trying to routing incoming traffic to my Exchange server. As f...
Hi All,we are having a cisco 8200 router running 17.09.04a and we want to configure dot1.x and mab configuration in the celular interface.I have followed the below guide in configuring Cisco Catalyst 8300 and Catalyst 8200 Series Edge Platforms Softw...
Hi there good afternoon I have issue with a switch, this one was formated, I think that, becuase in mode Rommon this switch dont show us any File IOS, somebody has the stepps for resolve this issue??
Hi, I have an LTE router connected over vpn. I have a working gre tunnel within this connection. I can force traffic across the tunnel and load certain pages on a connected laptop on g0 interface. But instead I'd like to only use the tunnel for multi...
Hi All,I need some advice on AAA config. My switches are able to reach the RADIUS but the device still accepts only local login.Please have a look at the config and guide me on how to correct it:aaa group server radius AA-RADIUSserver-private 10.169....
Dear all; I start my CPT 8.2.1 and since Friday till now, I kept getting this maintenance screen. Did I configure something wrong?ething wrongly? It was working all along will last Friday-ish... any advise will be greatly appreciated. Thanks!
I need to enable directed broadcasts on some SVIs. Is there any difference between me using these two configs:acl 1 permit 10.10.10.1int vlan 1ip directed-broadcast 1ip forward-protocol udp 10ORacl 2000 permit 10.10.10.1 any udp 10int vlan 1ip direct...
Hello, I know very little about configuring cisco hardware and need some help..... we are currently running an 1800 router and I obtained a new to me 1921 router and would like to replace the 1800 router with the newer one, I managed to get it factor...
The host for my current server (Windows Hyper-V machine with four or five VMs) that handles my email and web sites is going away. I'm planning on moving that physical server to my house and using DDNS to route that traffic in. Realize this is very lo...
