Routing

Hi, i have 2 internet circuits primarily for Remote access VPN, S2S and internet traffic, in other hand 2 circuits for DMVPN traffic for remote locations to reach data center for accessing internal resources and web traffic, i want to setup RA and S...

I have already looked at the PIX/ASA 7.x: Pre-shared Key Recovery and I don't think that is what I need

Dear Forum users. Hi there. I have a some trouble about interface overrun increasing issue. Here is our router interface informations GigabitEthernet0/0 is up, line protocol is up Hardware is CN Gigabit Ethernet, address is  MTU 1500 bytes, BW 1000...

 e-mail notifications and scan to e-mail from the copiers stopped working after adding second ISP using NATing, both use aspmx.l.google.com, regular e-mail communcation between users work fine. ISP was added for additional bandwidth. As soon as I rem...

Hello. I want to use two adsl lines on 887VA, one directly to dsl interface and the second on lan1 behind my provider's modem (bridge mode) and load balance them. Is this possible with 887VA router? Thanks.

Hii My Friends I have Cisco router 2801 and i need to implement DHCP Snooping on it But the command R1(config)# ip dhcp snooping not accepted by the router and not recognized  by it Ido R1# show version and the result is Cisco IOS Software, 2801 Soft...

Hi Folks Seek to know what purpose do the outer switches(Layer two switches between the Internet Router and Firewall) serve as depicted in the  http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/WAN_and_MAN/Internet_Edge/InterEdgeOver.html...

Dear All, NX-OS route distribution require a route-map. So, I am trying to redistribute lot of connected and static routes to BGP in a VRF. Is there any solution without making a prefix-list with all the static and connected subnets ? I tried the co...

Hi, i have the following network scenario: Location -A is the main Data Center in which internet is accessible 10.0.0.0 Location -B is connected with A by the same ISP with vpn tunnel (isis) but internet access is not allowed to its users. 20.0.0.0 I...

VWIC-2MFT-E1  not seen in configuration. After inserting module in Cisco3825 I not see it in show run, but I can see it in show inv and show diag Ustk_VG1#sh invNAME: "3825 chassis", DESCR: "3825 chassis"PID: CISCO3825 , VID: V02 , SN: FCZ101870EM NA...

Hi All,Does the Catalyst 3550/3560 EI support LLQ QoS?? I'm hearing conflicting stories from many people on this subject. I need to priorities traffic over a BT Les 10(Basically an Ethernet short haul repeater). I have a 3550 at one end and a 3560 at...