Routing

Hi..Want to know how to size the Power for the Switch.As per Datasheet ws-2960xr-24ps-i Switch will consume 370w. but in case my actual load is less(say i want to use 18 PoE Ports at 12.9w. How to size the UPS?Shall i size as per the Datasheet for 37...

We have a Big Band appliance which handles Cable channel feeds that connects to our ASR 9010. The multicast feeds are dropping every 3-5 minutes for a significant time yet the interface on the ASR 9K shows no errors or drops. Any help would be greatl...

Dear Cisco comunity, I'm new here so forgive me if this is not the right section. I come from 2 broken consumer level routers (Asus AC68U) and I'll never buy anymore consumer routers again. My question is, what specific router model would be a good c...

HelloWe are having a 1 Gbps ISP Link & we are using Cisco ASR 1k as our Internet Router. Peak bandwidth Utilization is around 450-500 Mbps. In the existing setup, we are about to replace the Cisco ASR 1002 with Cisco 3845.Current setup & utilization:...

From what I can tell phase 1 complete but, phase 2 doesn't seem to be working.   10.0.100.0/23 <==> Mikrotik Router (aa.bbb.cc.ddd)  <==Internet==> Cisco 2821 (ww.xxx.yy.zz) <==> 10.0.50.0/24   *Aug 23 03:37:14.497: ISAKMP: local port 500, remote p...

Hi, I'm in the process of building a new 7600 box to replace our internet edge router. A (difficult) requirement is that we need support for 2 PPPoE client sessions to our upstream provider. The feature navigator tells me that the PPPoE client featur...

Hi all,I am looking into deploying PfR on my network and I am trying to figure out if it's worth the investment as I have some old routers that may not support the this feature and plus I will have to purchase the feature licenses. These are the rout...

                                    Router#   SHOW ENV ALL Fan  1 OK ILP  Power Supply - Not supported Fan Speed Setting: Normal Hi  Everyone,I will appreciate if anyone could explain to me what the above message mean,I have a cisco 1841 router which...

I know there is a feature in IOS to filter LSAs from being inserted into an OSPF device's routing table.  Does this feature exist on a Nexus 3548?  if not, is there another way to prevent LSA's from a specific incoming interface from being inserted i...

Hello all, I have two catalyst 3750 switches, and they are connected by ether net to tplink ethernet to fiber box on each side. Switch A is connected to my router. Switch B is connected to my users. My user laptops are unable to connect to the intern...

Hi EveryoneI have come up with the requirement where i want to create the automatic failover for the internet between two of our datacenters. Here is my topology looks like:1- Each datacenter has its own internet connection 2- Each datacenter has its...

Hello  I have peering with two ISPs and i am receiving full routing table + default route with ISP 1 and partial routing table with ISP 2  2.1L routes + default route. Last week, ISP 1 was down, i am using route-maps with as path prepend for network ...

Hello;I'am trying to do the sizing of the necessary switch for our company. We need a switch core that related with access switch in each stage . What are the main factory that i must use it in the sizing? There is a method or sizing tool that should...