Routing

We use following command for QinQ(dot1q tunneling).interface GigabitEthernet2/0/8 switchport access vlan 75 switchport mode dot1q-tunnelwhat ever the packet coming into this port will be tagged with vlan 75 as outer vlan.But my requirment deffers sli...

Hi and glad to be a part of this forum.Recently purchased a new PC with Windows 11 Pro installed.  Also have 3 other machines, one has Windows 11 Home and one has Windows 10 Home and lastly, a Google Chromebook.Running a CenturyLink C1000A dsl modem ...

Hi All, While booting router, facing mentioned below issue. Please help me to resolve this issue. Upgrade ROMMON initialized PASSWORD RECOVERY FUNCTIONALITY IS DISABLED program load complete, entry point: 0x8000f000, size: 0xcb80 boot: cannot determi...

Dears I tried to install lab for ISE on EVE, ISE1,2, and AD installed on Server, Windows, and switch installed on EVE-eg, I configured int VLAN 1 on the switch with 10.10.10.100, as per attached I can ping Windows from the switch but I can not ping I...

Hello everybodyif i have big network and i run isis as routing protocol and i need to automatic load balance if the link reach 50% of the maximum capacity how can i do ti ? IP SLA ?Thanks,,,,

Hi,I have an issue with my guest wifi which is on a different v-lan 30. I can connect on the Guest V-LAN for just a few minutes, but only on one device, and then it drops.After that, I can no longer get internet access. I am using the AP208 and on th...

Hello everyone, i have a problem in MLS, i do all thing that required for MLS but when i want to ping anything it show me failed so can you see for my problem and the file in the down 

HI, I am using a CBS350-8P-E-2G. The issue is that when I try to assign port 1 to VLAN2, and port 2 to VLAN3. The internet does down. I tried to create a DHCP Pool to resolve this. But the service dhcp VLAN2 command does not work because there is no ...

Hello,We have some problem with one of our DMVPN config. Our customer is reporting a problem with the DMVPN tunnel disconnecting for one of their branches. Tunnel restart on branch router may temporarily solve the problem. Deleting and re-entering th...

Building configuration... Current configuration : 15772 bytes!! Last configuration change at 11:45:04 EDT Sat Aug 26 2023 by sclark! NVRAM config last updated at 11:36:33 EDT Sat Aug 26 2023 by sclark!version 15.5service timestamps debug datetime mse...

I have learned what is AD in routing protocols, and how routers are using them for preferring a routing protocol over another.my question is, what happens if I configured two dynamic routing protocols (for example EIGRP and RIP) on a network but chan...