Routing

Hi All,We have CSCO7600-SUP720-3BXL deployed in our network which has full internet feed that is close to 500K IPV4 routes. The mls cef supports maximum of 512K routes for both IPV4_MPLS, Its close to the maximum value.How can i increase the reconfig...

I found the problem, but what does it mean, and how do I fix it? S3#show interfaces fastEthernet 0/18 switchport Name: Fa0/18Switchport: EnabledAdministrative Mode: static accessOperational Mode: downAdministrative Trunking Encapsulation: dot1qOperat...

Hi,We are building three small data centers. BGP and OSPF will be introduced to route the traffic.I have a question about configuring OSPF.We don't have many routers but only two or three routers in each DC. When configuring the OSPF area on the rout...

This might sound kind of dumb, but is there much risk increasing my buffered logging from 8192 to 16,384? This is a 7204 and the show version is:Cisco 7204VXR (NPE-G1) processor (revision B) with 983040K/65536K bytes of memory. Seems like I have tons...

Hi,I would like to configure SMS / Email notification about Router wan link up/down. any one has done the setup please share the idea.we have sms gateway, Email server, and all syslogs are saving to syslog server.

 We have 2 Router 2951, both having 50mbps Link terminated on each router.Achievement - we have to do equal load balancing,at a time both wan link should be used and WAN Link Failover,Example - At a time both link should be used and if 1 link fails t...

Which regulatory domain should be used for Cisco AP AIR-SAP1602? We need to deliver them to Guatemala and El Salvador? For example we delvired AIR-SAP1602I-A-K9 to Argentina, Costa Rica and Paraguay. This was Regulatory Domain A.Could somebody help?

 Hello engineers,    our customer has a cisco 3750 router in which they configured PAT for internet access.  Total 500 users are sharing the 4 Mbps internet line ,Most of the time performance of internet access is good. But today the users are compla...

Hi, Can someone please guide me using Event MAnager Applet for following scenario. I have 2 WAN links. If one wan links gets down. Other link should get up. I tried by using IP SLA but i couldnt fine tune the vlaues properly. I want to use now Event ...

 I have a Network - 192.168.1.1/24. The range is fully utilized (all IP addresses are already assigned to hosts). How can I add 10 more hosts without changing the address or mask. Thanks, Manu

Is possible to configure wan load balance with 2 isp without bgp, with nat, using ios on 2911 cisco router? Different speeds of upload for each one..

I'm building a transit network with our internet provider terminating on a layer 3 switch. The IP addresses below are all made up. | ISP Router 1.1.1.1/32 | ---------- | Layer 3 Switch 1.1.1.2/32 | And the ISP will route our public range (2.2.2.0/24)...

Hi all,I am setting up a new 2911 with a ES2-16p switch module.  My question is, do I have to set up a trunk between Ge 1/0 on the router and Ge 0/17 on the switch if all traffic will be carried over VLAN 1?  I know this is not recommended usage, but...