Routing

HelloWe have been upgrading our WAn links and running fiber from Dmarc to router. I use the above Gbic because they workand are less expensive than others. I have been runing into problems with speed/duplex settings. The "last mile" LEC has had to ch...

How to check bandwidth for per host utilzation in a router currenly using Cisco 1941/K9 Router?

Hi ExpertsI have Cisco Nexus 3000 configured with VPC domain, port channel and vrrp.Whenever we reboot the switches the traffic dont get through until and unless I issue the ping myself.Once ping is issued the first packet of ping drops and then succ...

Hi,Example below..O E2     10.44.240.0/20 [110/0] via 172.27.4.50,O        10.44.240.0/24 [110/4] via 172.27.4.50, I want to filter out the 10.44.240.0 /24 - but keep the /20.I have my access-list denying the routes, then my distribute list under OSP...

Hi all,If i have 1M WAN link, what would be the value for traffic shaping: 1024000 or less? Bellow is an example of configuration on one of the routers in my company, and shapping value is set at 768000 with explanation that it always must be less be...

Platform: WS-C4506-E (MPC8548) IOS: cat4500e-IPBASEK9-MThere is a VLAN 10 SVI on this switch and the ACL is accounting lots of multicast traffic. The SVI has both primary and secondary range configured.Vlan 10 has many host in primary and secondary r...

Hye all,I intend to manipulate outgoing bgp traffic.Which parameters are best suited for this?

Hi,I face some problem on mulitcast routing with static RP and sparse mode.1. All routers was configured with Static RP ( group address is not defined because mulitcast source for 224.1.1.1only)2. RP should be added diffrend router for group 239.1.1....

Dear all,I was wondering is there anyway to configure multilink on ethernet interface? I understand that there is a configuration for Serial interface,which is called Multilink PPP which bundles a few serial interface togehter, but I was wondering do...

Hello,I have an MPLS link where I have QoS configured on the outside interface (Verizon MPLS), we have noticed lately that when an user from other MPLS location tries to upload a file to the location in question, ping times to all that location incre...

Hi,I have seen the Nexthop label Forwarding Entry , Incoming Label Map, FEC to NHLFE Map in MPLS rfc 3031What these terms mean?Is it possible to view these information in Cisco routers (Possible means what is the command)Otherwise how to relate these...

Hi all,We have two internet connections in our org. One for Primary and the other for secondary. Both from different ISP's. When we tried to do a failover test, the traffic is unable to shift to secondary internet. we found the trace to be reaching u...