Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi All,We need a CISCO router or switch with both wired and wireless connetions.Initially we have a router (ADSL) provided by the Broadband service provider with wireless and wired access but It's not enough now because the number of users are now in...

  Hi Guys,I have gone through so many documents of failover /redundancy scenario , but didnt got a convincing response. And trust me so many guys have posted these ques ??One of my client is taking Dual Links from differnet service provider  terminat...

Hi all,When considering ISP redundancy with BGP, we follow this document:http://www.cisco.com/en/US/tech/tk365/technologies_configuration_example09186a008009456d.shtmlHowever; if we use different BGP routers for different ISPs, does it change anythin...

m.turunc by Level 1
  • 4218 Views
  • 1 replies
  • 0 Helpful votes

Guys,  We are in process of ordering new Cisco Routers, i need intruction on what series of router we should order.We need the Router to have support of the following features  >- Policy Based Routing    - IP SLA                  And the Router will ...

I have a remote office with a 1.54mb circuit connected to our private MPLS network.  Our main office has a 20mb conneciton to said network.  I want to set a QoS policy for traffic from the remote office to our Avaya subnet within the main office.  Th...

0rsnaric by Level 1
  • 3927 Views
  • 4 replies
  • 0 Helpful votes

   on our cisco 3845 router    we have  recently applied a qos policy on a fast ethernet where  our MPLS link is connected. We have already having a GRE tunnel over the fast ethernet with one of our site. Now we are observe the application working sl...

Hi I have a 1921 router with two wan interface configured, one is primary and the other is standby or backup in case the primary goes down, I was able to configure links to failover from primary to backup once there primary is down, but how do I conf...

Hello Experts,we have a GRE Tunnel in our setup and the two head/end routers form an OSPF neighborship over this tunnel. at the times of traffic congestion we lose hello packets and it causes OSPF peering problems, flapping. i want to prioritize my O...

smehrnia by Level 7
  • 3975 Views
  • 4 replies
  • 0 Helpful votes

Hi all, I have 2 circuits within the same ISP. Our ISP said we could do a failover setup using BGP, using their AS number. I would like to setup 2 routers with HSRP on the LAN side, and use the router connected to our 100Mb circuit as a primamry rout...

  Hi All,Need advice  i am proposing cisco 892 series router for multi VRF Configurations-MPLS. Is there any challenge you foresee in this  architecture.PE-CE ---> BGPIf possible pls share brief  sample config.

Unanswered Topics