Routing

Hi.I have configured my CIsco 2911 router and there seems to be something wrong with my configuration regarding subinterface 0/0.102The hosts on this subnetwork cant access the Internet and i cant spot the error.Hoping someone could shine some light ...

Hi I want to  migrate Exchange server to Exchange 2010, I would like to know if ACE and SSLM support Subject Alternative Name (SAN). 1.   Can the current CSM (WS-SVC-SSL-1-K9) support SSL certificates that have Subject Alternative Names? I.e. a certi...

Hello,I purchased 2 Cisco WAP4410N and i configured them on the network as 192.168.1.241 and .242.I see both SSIDs i created and they are named Cabo1 and Cabo2.When i initially did the setup I was able to log into the webbased interface through both ...

Hi all,Currently, I have in a number of remote sites (with dynamic public address) a C800.On this Cisco, I have a config for initiating an agressive-mode tunnel to a central ASA.relevant part of the config:---crypto isakmp policy 10 encr aes authenti...

I am labbing my IPv6 network:My network addressed with 2001:DB8::/32 prefix. I have done a splitting so that the 2001:DB8::/33 belongs to site 1 and 2001:DB8:8000::/33 belongs to Site 2.I have a host on site 2 with IPv6 address 2001:DB8:8000:600::100...

HelloRP/0/RSP0/CPU0:Router#sh  inter descriptionWed  Jun 15 10:40:49.347 HKTInterface           Status      Protocol    Description--------------------------------------------------------------------------------BE1                 up          upLo0  ...

I have been searching the Cisco WEB site in vain for the type of documetation for the 26-pin smart serial cables that I can find in Document ID: 12222 and Document ID: 46802 for their 60-pin connector cables.  Do they exist?  If they do, where and ho...

Hi,I'm planning to use this card for a 7204VXR with NPE-G1. I'll be using it for data in the customer data center; in remote sites customer has 2811 with VWIC-2MFT-E1T1, so I assume it's using a framed E1 (g704-->1984Mbps). Can I use PA-MC-8TE1+ in t...

Hi all,I have a problem configurinng object tracking with cisco 881G.When traffic is routed by fe4 (wan) I can't achieve the outside world. When traffic is routed by the backup line dial 1, I can achieve the outside world.I add a txt file with config...

Hi All.Im very new to BGP. I dont have any working experience on BGP. Im working in Network Service Provider(Not ISP) company. In near future, my company going to setup own Data Centre for Customer use where they can rent rack for thier servers and u...

Using a small network (WAN) with three 1921 routers (IOS 15.1(T)) connected via E1 links. One host (industrial PC - core 2 due running Win XP Pro) connected to each router. The spare Gigabit Ethernet port on each router is bridged with the active one...

HelloHow to identify if the cisco hardware support Dual Stack ( IPV4 & IPV6 ) , experts plz do share light on planning and migration phase to IPV6cheersAnthony

Hi, Does anyone know if it's possible to retrieve Tengig interface serial numbers via CLI?  We have a couple of them in 3750 switches, and we need them for our inventory.