Routing

I have a 3750 stack and want to to a etherchannel trunk across the stack.  I have created it and everything looks fine but if a do a "show vlan" the etherchannel ports do not show under the vlan's at all. *********************************************...

Hi to all,I need redirect a range of ports from my public IP on the WAN side to a host in my LAN, and keep the statics NATs/NATPs too. As far i know this would be no posible because Cisco IOS for 877 does not have a parameter to specify a range of po...

Hi, hoping someone can help.according to the cisco documentation 1p1q0t RX queues default to cos 5 mapped to the priority queue 2 threshold 1.Receive queues [type = 1p1q0t]:Queue Id Scheduling Num of thresholds----------------------------------------...

Is there a way to configure the console port on a800 series (831?) for use as a terminal server async port to remotely connect to another devices console async via a telnet to the 800 series, similar tothe use of a 3600 series as a terminal server?

We just upgraged 6509 IOS to 12.2(17r)S4 (s72033-adventerprise_wan-mz.122-33.SXI4a.bin) after that when I deployed service policy on a layer 3 interface I got a message :priority command is not supported in output direction for this interfaceConfigur...

Hi,We have two 6500s located in two sites. We have purchased a 2Mbps site-to-site L2 circuit(ethernet) from a service provider beween these two sites. We have connected the ends of this 2Mbps link to the 6500s.We are carring multiple vlans on this L2...

Hi,I am planning to extend my bgp routes of Private Network Cloud to core switch which is cisco 4510 switch.Before that just wanted to make sure the 4510 switch which is acting as core is capable of handling present 4300 bgp routes of private colud &...

Hello,I am upgrading new IOS image on a stack switches of 9 (3750G-48TS) for enabling faeture of SSH as it is currently lacking SSH login feature. I came across through cisco documentation that I can upgrade the new IOS image on all 9 switchs of a st...

I have a serial interface card (s0/1/0.16) which we curretly use for our T-1 connection.  I have second T-1 line coming and was wondering if I could use the "controller T1 0/2/0' interface for the same purpose as the serial interface?  (see config be...

HiI really need help on making a configuration in a router 2600, I have 2 ISP (one Cantv and Movistar) one of them will give me a 2mbps of bandw with a static IP and the other will give me an DHCP IP address With 1.5 mbps, and I have to make a load...

We want to connect as follows:Internet <--> ISP PPPoE DSL Modem <--> Cisco 881 (DMVPN) <--> Cisco 871 (IPSec VPN) <--> LAN1 (Private)                                                                 <--> LAN2 (private)We have 1 DSL internet connection...