Routing

Hello,   I guess this has been asked in past, but I need some help. I was suggested that we use following config. I want to know, your opinion, before I install this 1841   So we have 2 megabits/sec (up&down) leased line and we want to allocate 1mbps...

Hello,I am looking for a solution to carry one L2 Internet vlan on 10 remote dsl/Atm connected sites.For security, this L2 Vlan has no IP add and is not routable across internal networkOn each remote site, is a C870 router used for internal people.I ...

Hello,we are a little ISP and our design is based on private address. Our internet router is translating now 50.000 entries.The issue is that we are used static NAT:......ip nat inside source static 10.17.254.129 <public_IP>....If we use the command ...

Hi Guys!How to design a DR Site?powerfull documents/Link very much appreciatedThanks allThanks CISCO

Hi there! Once again, let`s discuss VPN and MTU What we have? Ethernet LAN, L2TP to ISP and IPSec with AES crypto in tunnel mode. So protocols overhead is 40+73 bytes (L2TP + ESP). What is the best way to avoid fragmentation for all IP protocols on ...

I could not ping  to 140.1.2.0--200 from our lan pc(192.168.1.x),.But ,when I add routes to CS-2 router(Cs1 =cs2) as ip route 140.1.2.0 255.255.255.0 192.168.1.46 and  for the ASA as route INTRANET 140.1.2.0 255.255.255.0 192.168.255.14 1,I could so...

Howdy, I have a Cisco 1811 router, I also have 2 internet connections. A T1 and a Cable modem. I have them both configured on the router and they seem to be working OK. However failover is not working, What I would like is for one internet connection...

I have a WRVS4400N for my home office and it works great for inside the house. I also have a gazebo about 120 ft away from the router that I like to sit out on in nice weather to work. I get very low reception out there (1/2 bar) and would like to bo...

  Hi All,I have a requirement to rate limit one of the customer to 40Mbps. Unfortunately I have to do it in Cisco router. The customer is landed on POS interface with encapsulation configured as FR. Customer has got 2 services so 2 different DLCI are...

  Hi All,I have a requirement to rate limit one of the customer to 40Mbps. Unfortunately I have to do it in Cisco router. The customer is landed on POS interface with encapsulation configured as FR. Customer has got 2 services so 2 different DLCI are...

Hi,I am new to the SA520 and have the situation I describe below - any assistance will be greatly appreciated.I have a SA520 at my site and need to setup a site to site VPN with another company. Two issues: 1. My ISP connection to the SA520 uses PPPo...

Hi,can i config each port on the NM-HDV2-2T1/E1 module one as a E1 and  the second as a T1 ?, or i can only config T1/E1 for both ports ?thanks,

BackgroundHQ has dual ISPs (a.b.c.d is fa0/0 and e.f.g.h is dialer1). Branch has single ISP (i.j.k.l is fa0/0). Both sides are using Cisco 2621 routers.There are two GRE tunnels created between the HQ and Branch offices. On the HQ side Tunnel0 (ip = ...