Routing

What is an Interface Virtual-Access1? I recently noticed this interface on a 2800 series router after installing a second T1 circuit and creating a Multilink combining both my T1s. I hadn't noticed this interface before. What is its purpose?

HI,Running into an issue trying to install a GEIP+ card into a 7507 running IOS 12.4(25) Service Provider, with RSP4's. The following error is displayed:{Sep 9 08:45:35.915 CDT: %DBUS-3-SW_NOTRDY: DBUS software not ready for slot 6 after DOWNLOAD, ...

I need to verify this image (c2800nm-adventerprisek9-mz.124-25b.bin)using /md5. I can't seem to find the location for thd MD5 values. Does anyone have the URL? Thanks.

Looking for confirmation I can do this. 1841 has 2 interfaces: FE 0/0 and FE 0/1. 0/0 is WAN w/public IP of 65.183.46.182. LAN is FE 0/1 with 192.168.1.1. Currently have users using browser-based access to IP cameras by http://65.183.46.182:xxxx, whe...

I have a site-to-site vpn with two 2811 Cisco Routers with 2 interfaces each (LAN and WAN) and a GRE Tunnel. I have an ACL implemented to allow some PCs to have access to the VPN and another PCs to have access to Internet but deny access to vpn. I wa...

I have an MPLS cloud into which I am injecting some local routes from two different end points of the cloud. One site (A) is the primary site and should always be selected for network 1.235.0.0/24, while site B should always be the backup. In addit...

I find that NM of CEoIP does not support E1 with AMI. I suppose CEoIP provide a transparent solution to T1/E1 over IP network. My project is to simulate a E1 tie-line between two location over IP WAN link. As it is not support E1 AMI, can I use the u...

We are going to implement a new project for a bank so I wanted to ask you the following: 1) Do Cisco routers have the capability to support Enterprise Extender termination? What I mean is if we can terminate the SNAsw traffic coming from Branches (ut...

what material i can prepare for Routing,Right now i m concentrating on Networking Academy s Student Labv,Testking for dumps,CBT &*trainsignal is it enough or i have to go to Exam cert guide& Self study

I monitor Perfomance for a Large Network. We noticed that an ATM Subinterface has been dropping around 30,000 Packets per hour. We looked at the higher level Links and they are running clean with low utilization. The Util on the Sub interface is runn...

Hi guys I have a client who is applying for 2 internet leased line circuits from 2 different ISP's.I have 2 - cisco 2800 router for the internet connectivity.I have a L3 switch in the internal zones of the routers.Both the ISP's have given /30 public...

Hi,I'm building a VPN IPSec with Vitual Tunnel Interface (VTI) and I addeddynamic routing in tunnels with OSPF.Hardware used : ISR 3825 HSEC/K9I have about 50 peers in this VPN connected in full meshed on Internet.We use OSPF in Point to Point mode, ...

Hi,I have two routers which is configured in HSRP,and our LAN is using the HSRP IP as default gateway.the two routers are connected with 2* 7 MB metro ethernet links connected on one ISP.how do I load balance both the circuits to use same time for LA...