Routing

Good day,I have a remote site with a WAE and a data center with a WAE.. Download time is fine but upload time is alot longer.When I upload the file to my file server at the data center after changes are made, should it send the whole file or just the...

Hi,Please how can I monitor or know the amount of packets flowing through the port of a router or switch.Is it possible to see a real time flow statistics.I configured 'ip route cache flow' on the interface of the router and I can use 'show ip cache ...

Hi all....I have two location Mumbai and pune configuring with two link using BGP and other static route.From pune i am using static route for both the link.Pls find the attachment.I test the config,At pune when reliance link goes down, traffic autom...

Hi to all,I have some questions about the topology in the attached file. As you can see I have a ring topology between three buildings, but the routers E and F have only 1 successor (and no feasible successor)to reach respectively the network a and b...

Hi Folks,I need a little help. I have 2 sites that are connected by a metro ethernet using a 3560 & 3750. We experience a congestion, I tried to run ipaccounting on the interface vlan that links the site. I was able to apply it on the 3750G but when ...

Hi,I have to recovery the login and enable password for a Cisco 6524 and Cisco 7604 with Sup32.How can I do?In fact I don't find the recovery procedure for 6524 and for Sup32 on cisco website.thanks for helping meantonio

Hello,I Know I am asking for too much help here, but any suggestions are appreciated. Our organization has three locations, all of the them have their own internet connection and other resources {FTP, MAIL}.Now as per new company policy the Location ...

Hi, my CE router is connected to two PE routers in Provider edge in MPLS VPN. I need to configure my CE router to forwared traffic to PE1 router as primary and PE2 as secondary. How do I configure in MPLS VRF. Please help me.

I have created a successful IpSEC VPN tunnel between a Linksys RVL200 and ASA 5505 using the Site to Site VPN Wizard. After settings on both devices are matching, the tunnel connects but a client software on the remote site cannot use port 3306. Do...

Hi,I have 2 BGP links at my gateway router. Link A is 10 Mb bandwidth and receive full internet routing table from ISP A. Meanwhile link B is 20Mb bandwidth and receive summarize routing table from ISP B. I want to make Link B as primary and have con...

What does Cisco consider a frequent occurrence of SBE on 12000 line cards?Below module did have one recurring logbut month apart.FRU: Linecard/Module: 4OC48E/POS-SR-SC= Processor Memory: MEM-LC4E-512= Packet Memory: MEM-LC4E-PKT-512= SL...

This is a design concept doubt.I request you to share your ideas so that I will reconsider to use this module for this scenarioI am going to use HWIC-4ESW for Cisco 1841 Router. I Know by default VLAN 1 is configured with the IP address for these 4 E...