Routing

HelloMy Catalyst 6509 starts with the following outputSystem Bootstrap, Version 7.1(1)Copyright (c) 1994-2001 by cisco Systems, Inc.c6k_sup2 processor with 262144 Kbytes of main memoryAutoboot: failed, BOOT string is emptyrommon 1 >If I run the dir b...

1.I have a switch network with like 5 vlans configured. I notice ther is a broadcast on the network because local ping is return with high latency, how do I troubleshoot, detect and Isolated the source.2.On Vlan 2 on my root bridge, below is my out p...

My requirement is, whenever I connect desktop on the switch, then port should be in forwarding mode within 3 Second. If I enable Portfast, then how much second it will take to gain forwarding state ?

Hi, I have configured MACRO on the switch. I have little bit confused. Should I give number in Vlan (vlan $V). I am seeing only Dollar Sign in the configuration. Please help.macro name Port switchport mode access switchport access vlan $V spanning-tr...

I'm looking for a way to change the ODR distance on the spokes so they can prefer one hub over the other w/o balancing. The solution has already been proposed by CSCdr35460, but configuration details are unavailable.

Hi, I have configured MLP over PPPoE and ADSL. Though theconnectivity is up, Interleaving is always reports as disabled on BRAS while CPE is enabled. The ppp session also goes up/down about every 2 minutes and i think due this problem.Without interle...

HiCan you tell me what I do for resolve this issue (See attach).thanks

Out of the box SLM 2048, connected 1 PC and our Linksys BEFSR41 Router, powered it up and tried to access the web based utility. It gives me this:Connection InterruptedThe connection to the server was reset while the page was loading.The network link...

Our 7600 routers doesn't report the number of hits on an acl statement when i apply an access-list in the outbound direction on a interface. This is not a issue on a 7300 router.

Hi,We are planning to deploy GLBP on two of our internet routers (Cisco 3845),Both the routers connect to same ISP & bandwidth of both of them is 5MB.Both the routers are terminating on the inside firewall (non-Cisco Fortigate) using an L2 switch.We ...