Routing

Hi,I have a question of processing ACL.Catalyst6500/4948/3750 is processed by Hardware(TCAM) of ACL.Is Cisco 7301 processed by Hardware(ASIC)? or Software(CPU use)??Regards,

I have a site that uses a T1 for internet. They also have about 4 site to site vpn's using this link. I have an ASA in place doing NAT and the VPN's. I've got an 1841 in place terminating the DSL. I want to send all internet traffic to the new 18...

Hi,I've been doing a bit of reading recently which indicates that VDSL and VDSL2 are up coming WAN technologies. Apparently in Asia they are projecting that VDSL2 will replace ADSL soon.As far as I understand VDSL is similar to ADSL in the fact that ...

All,If I have this:router bgp 12345 no auto-summary network 199.199.199.203 mask 255.255.255.255 network 199.199.198.0 mask 255.255.240.0BGP will only advertise 199.199.198.0/20 correct?And if I have this:router bgp 12345 no auto-summary network...

Hello,we have in our test lab a WAAS System with Inline Network Adapters, the interception is in inline mode.Can the WAAS System also optimize VRF's and can i choose which VRF will be optimized, as it acts by vlan's?We have two 612-K9 WAE's for core ...

What is the best way to look at a router and/or switch to determine its health other than just reviewing the logs?

Hi everyoneMay be my problem is very small for most of u people but iam badly stuck with it. any kind of help will really be appreciatedI have my private IP which i cant advertise to MPLS cloud as my remote sites also have same private IP so i NATed ...

Hi all,How many primary vlan can be created on a switch for confiruring PVLAN.Regards

Hi,I have a query about checking loop in Multilink it has been observed in the case of E1 Controller the loop given by ISP has not being observed in serial interface. Once we remove the E1's from Multilink we could see the loop….In normal cases we ...

Hello all,Does flexlinks only work when physical link goes down or how?I have two switches with two redundant links between them. The redundant link goes through radio.My question is that, will Flexlink detect interference on the primary link and swi...

Hello All, I have been trying to forward traffic through my router to my my VPN concentrator. Please look at the config below and let know if I the correct nat confis as well as the correct ACL's. My vpn concentrator's internal ip is 10.100.1...

Can I bundle two POS (with STM-16)between a 7609 (Router A) and 12010 (Router B)? If yes, can I use the bundling to carry layer2 VLANs (one VLAN from router A to B, another VLAN from router A to router C through router B)?

Hi all,can I build a tunnel over a tunnel without any known limitation ? let's say Tunnel 100 is a DMVPN tunnel , tunnel 1000 is a gre tunnel between my site and the service provider. will be there any limitation to run tunnel 100 to be sourced out t...