Routing

Dear All,I would like to ask you some question that on Cisco switch,Router and ASA how can we know that loop cable in those device and which command that we can show? and how can we now a virus attach on device?Best Regards,join

i want to cover a site by using HWIC-3G and i asked my service provider about this service and he told me that he will give me 1.8 Mb/s for download and 384 Kb/s for upload . i see that this speed is low specially that i will use video conference aft...

After few weeks the unity stops working.The Ip phone gives busy signal.When i restart the cisco unity server it starts working.I don't know the cause of problem.Please help!!!!!!!!

I have a T1 that is handed off with ethernet. I need to do QOS on the line for bandwidth sharing of two servers. Ihave configured the fa0/0 with a few policies but they all seem to be using the 100mpbs to base the QOS on. I have set the bandwidth com...

Hello,I have an eBGP peer with one of my customers, and we currently only send them a default route, using the default-originate command.When they reboot their router, the session drops of course, but when it comes back up, the session established, b...

We have recently implemented a new Class of Service policy on our MPLS router. I need to know an effective way to troubleshoot this, as when i do a "sho policy-map int XXXX", it does not show any packets being placed into CoS2, 3, or 4....Thanks

I currently have a Cisco 2851 router running the following IOSC2800NM-ADVIPSERVICESK9-M), Version 12.4(9)T We have two additional HWIC-4ESW cards installed in the 2851 router.The first card works ok as a layer 2 and 3 but the second card only works a...

I have point to point t1 and occasionally we go higher than 1.54 Mbps. Does a full T1 have any room to burst more than 1.54 Mbps?

hi,we are planning to add one more link between two location for the backup. right now we have VSAt connection with 256 Kbps. we are already running OSPF between these two location. the problem is that we dont have enough ethernet interface to connec...

guys can someone tell me what exctly Ip classless means....the word which is comonly used in books is discontiguous subnets .......can someone please tell me with easy example what discontiguous subnets or network means...thanks guys

Dear All,I am planning to upgrade IOS on MSFC card in 6500 catalyst Switch. but this Switch is having dual MSFC card, could anyone help in tell how to do it or please share the document for the samemodule out put is pasted below.----------Mod Slot P...

guys if we have two isp on one router.......so what is the way to send all routes to one isp and if it fails it shd go to other isp????

I'd like to exclude ftp to be classified in a certain class af31. Would this work: class-map match-all af31match not protocol ftpmatch access-group name af31(The named access-list af31 contains further statements to include certain source and destina...

Dear All,i having braodband connection 512 kbps at secunderabad side and we having leased line secunderbad to banjahills now i want to internet at banjara hills side trough secunderbad broadband.