Routing

Cisco VPN clinet needs to go out. What port/protocol needs to open in firewall? Please help!

Should the invent txclock command help eliminate some of the high errors seen on these Hssi point to point connections? I'm looking for a solution that will eliminate these high errors seen. Of course the provider always says no trouble found. The...

I have branch stores that are using the c881 router. We're running voip over them but some of the connection have some packet lost on the provider side. Does anyone know if this series router supports FEC and can someone point me to a doc to configur...

Hi Guys,Can anyone point me to the right direction as to how I can redistribute EIGRP default route (0.0.0.0/0 172.20.88.242) into BGP? I have prefix lists which only allows selected routes. Redistribute EIGRP already in place in the BGP. Do I need t...

Hi Folks,Have a question that I hope you can help with.Have two 6500 switches that are directly connected via a GigE Link.Running OSPF between the switches. At layer 3 the switches are connected via a point-to-point connection. I am considering two c...

Hi,At the moment on our site some of our Cisco devices are a few seconds out and in some cases, they are a few hours out. We hope to sync up all our Cisco devices to our Domain Controllers as they are configured as NTP Servers.What I was proposing to...

We have a connection to Verizon MPLS via BGP.My main branch ASA# is 65001.We are upgrading out connection from X6 t1 Multilink to 15M DS3.My loca AS# is 65001.Verizon has given me the same AS# for my new connection into the MPLS cloud.So the config w...

I have understood that layer 2 switch is only interested in MAC addresses so why do switches keep an ARP table?We have some issues with a client who has connected a switch between multiple WAN connections and an ISA server. Each of the WAN devices is...

Why is outbound service policy command not supported on the egress of the 3560 switch. Please explain with a reason and any work around for this issue.

Hi Can you tell me how to calculate bandwidth using snmp index ifInoctets and ifOutOctets.I can see the output of this indexes using snmpwalk command at different time interval.But how do I derive the utilization when it reaches 80%.Archana.

hi, i have 4Mb bandwidth terminated on my Gigabitethernet interface. when i issue sh int Gigabitethernet 0/0 i found that there is " Available Bandwidth 3072 kilobits/sec" what does it means?The second part of the question is if i the bandwidth is te...

Hi,I am totally confused, why Lock-and-Key Security (Dynamic Access Lists) is used. Please help.

how to configure 2mft-e1 cards on 2811 router point to point.