Routing

Hi,I need to connect couple of routers through terminal server for management.Can anybody provide the configuration of terminal server to Host for access?Regards,

Hi,I am trying to locate a card and/or router that supports the following:Need to split my E1 up in more than just two channel-groups.So far I always run into the limits of only being able to create maximum two channel-groups.Can anyone suggest a car...

hey all, anyone know how to encrypt the password under line vty? it is a level 7 password and can be easily decoded. we used the global service password-encryption command but it only encrypts the enable secret to level 5. the vty still remains at le...

We are using Class of Service with our MPLS VPN provider for voice/critical data. I would like to have our edge router configuration verified. I wasn't sure about marking on the egress interface (multilink1). Is this ok?class-map match-any dscp26 ma...

If i have multiple interfaces configured on same router with dense mode, How can i make traffic received on dense mode interface (Interface A) broadcasting to another dense mode interface (Interface B). Downstream router on Interface B is not sendin...

Hello All,Trying to make sure I understand the use of route-map to redistribute routes from one routing protocol to another. See the attached diag to reference the configs below. I am trying to redistribute routes, cut out feedback, and adjust metr...

Hello there,Anyone has seen a problem where you cannot establish 2 BGP sessions over a single IP?I have 2 switches trying to use a single IP in another switch as a BGP peer and only one is successful.If I shut one neighbor down , the other goes up.ne...

Please, I need the part number of Wic-cover the 2800 series router. I looked at the cisco site but not found. The Wic-cover is equal to that: (http://cgi.ebay.com/Cisco-Router-Blank-WIC-Cover,-For-Cisco-2600_W0QQitemZ130283391126QQcmdZViewItemQQimsxZ...

Hello, We are looking for a way to automate ACL changes for incoming IPs. We are currently allowing certain IP's at the application layer, but would like to move this to the router. We would like it to be automatic every night when we update our da...

Hey Guys,I have a dialer interface that seems to have defaulted to 56k as it's bandwidth. I'm using this at a branch and the download is 6MB and the upload is 800kbps.How do I configure the dialer interface to reflect this.CAONTO-HO#sh int dialer 1Di...

We are getting scanned, by request, and our Internet router is failing because they say it is responding to this port. I guess I could make an access-list to block it but it must be a service that can be turned off. Does anyone know?

Hi All,We have around 5 routers in a single LAN where we are running OSPF. The issue is one router we configured the MTU as 1546 bytes but the other routers are configured with 1500 bytes. Initially we had OSPF neighborship issues on the LAN and were...

Hi to All, is there a document (or on the feature navigator) where I can find which IOS release support the BGP 4-Byte Autonomous System support ?

I am trying to configure an 877 on my home network in the UK. I have just switched provider to 02 as they will let me use my 877 router & Sky would not. However they do not support the cisco router & are not very helpful with information re the confi...

Hi,I'm trying to upgrade IOS in Cisco 7204VXR.Actually, it's working c7200-ik9s-mz.123-5a. I've tried to upgrade to c7200-ik9s-mz.124-23, and I've change boot system to disk2:c7200-ik9s-mz.124-23.bin, and other IOS, but everytime I restart the router...