Routing

how i can i configure tunnel between two routers sepreted by many ( other hops (2 or 3 routers)???

Have a problem with my ISP or the ISP have a problem with me. A ------ B ---------------- C 3750 800 800 my isp ispI have a static route pointing to "B" -"- 2 3750 with hsrp on the vlan.If I ping...

Hi Everyone,We have 3 routers, like this:other routers--A--B--C--other routersEach router is in its own AS, and EBGP is set up between A & B, plus B & C. We have IPV6 running. We'd like the routes from B to A and B to C to be load shared. Do we need ...

On our 7513 router there is no crc command for our OC3 POS card.I did a show diag command and it says:POS PA, 1 port, PA-POSDW-SM\EEPROM format version 1HW rev 1.31, Board revision B0Serial number: xxxxxxxx Part number: 73-2107-07Our 7513 router is r...

guyz , what command to enable SSH in rotuer 1751. thankx for reply.

hiI Have intenrnet through sattelite , the sattalite use two different path one for transmition and the other for recieving , Satalite dish --> DVB--> switch ( for inbound data) Satallite dish --> Sattelite modem--> Router (Cisco 1721) --> switch ( o...

Some products have part numbers with an equal sign (-) at the end and some don't.And some products have both, for examle,15454-DS3-12 and 15454-DS3-12=Can you explain this please.

My 40 site company is currently moving from a predominantly ‘site-to-site’ IPSec VPN solution (Hub and Spoke), to a L3VPN (MPLS) solution with our Telco carrier. I have a question that I am hoping will assist in our migration. Our provider is request...

Hello,I'm having problems with an ISDN router. It's a 2620 with a QUAD BRI card with integrated NT1s running IOS 12.2(7b).The problem is that every now and then I have to do a "clear int bri1/x" where "x" is either '0', '1' or '2'.The output of 'sh ...

Hi, We’re having problems with a cisco 2600. It has two full T1 lines connected to the two serial ports and it seems to be creating a loop. The situation is the following:If we leave serial 0 up and shut down serial 1, speed is 1.5Mbps If we leave se...

Hi,Our CPU is always at 99%. I managed to log into the router to kill some of the NAT and got it down a bit.Is there something wrong with our config that will cuase it to lag?Here are the big % CPU processesCPU utilization for five seconds: 71%/18%;...

HiI’m trying to test classful routing by rip version 1. The network diagram as following;network 133.247.4.0/24|R1|network 10.3.3.0/24|R2|network 133.247.1.0/24The configurations as following;R1:interface FastEthernet0/0 ip address 10.3.3.1 255.255.2...

my line is E1 and use CBWFQ. I know output drops are caused by a congested interface. in fact, sometimes I found that the line don't congested but output drops increase so fast. I am sure short burst is not exceed 500kbps, so why the output drops? ...