Routing

folksi'm trying to create an object group for an acl on a C3845-ADVENTERPRISEK9-M), Version 12.4(23) but the object-group command isn't availablecan i do this usnig this IOSthanks to anyone taking the time to reply

Hello,I have a problem to configure a Serial Interface connected to a ISDN PRI.The Layer 1 is up, the layer 2 is inTEI_Assigned state, but I can't making any calls trough thsi interface.I receive this message all the 11 seconds:Q931: Ux_DLRelInd: DL_...

Our company employs a UC520 switch with what i guess to be Wireless capabilities. Now i've been searching around the forums and cannot really find an answer to my question. I have setup an SSID through the configuration manager for wireless access bu...

Dear all,RT, it's very strange. Did any one meet that situation please?Internet----Gateway(Cisco router)----CiscoSwitch----My end pointWhen my end point is a PC connected, and ping to the gateway, it's fine. But when it switched back to the C851, aft...

A quick question, I'm trying to run IS-IS over frame relay studying for my CCNP on a Cisco 1750 Ver 12.1, The "Router isis" command doesn't put me in the router config mode, does it mean that ISIS is not supported on this router ?

Hi all:Could any one suggest IOS that will support IKE fragmentation on 7600.i found that IKE fragmentation was supported from 12.4 and cannot fine 7600 support thatsup720 with MSFC3 and PFC3ChaoVishwa

I have an MPLS network with a 9Mb, Multilink PPP pipe at the core and T1 or less pipes at the branch offices. We are connecting to our MPLS provider via BGP and we are using Cisco WAE's at each site with v4.1.1c of WAAS code as well. The problem is...

guys i was looking at one of my router (work) and saw a strange route-map...the router has RIP and ospf running....in redistirbution there is a rouite-map....which says as followroute-map xxx deny 10match interface null0route-map xxx permit 20why is ...

I have a client that currently has two sites connected via IPSec tunnels running on Cisco ASA 5505 firewalls. They want to add a T1 as a more reliable link between the sites but keep the VPN for failover and the ISP links for Internet traffic. They...

We have a 3745 that has a DS3 connection into a frame cloud. Yesterday we noticed that the serial interface had almost 100% of bandwidth being used outbound. I set up netflow to see what was using it, and it wasn't consistent. I tried to block ports ...

The IP range 10.10.10.0 must be given access to servers, i don't have ip addresses of servers but i have their names.Is there anyway to achieve this using PIX, ASA or Router?

Hi,I am facing Slip error in two contoller E1 ports.Service provider tested the link several times with error free...router vender came and tested every thing gave the update all are fine ...changed the E1 controller card and also the router ...no us...

HiI have a 2801 with 2 interfaces Fastethernet, one interface is connected to ADSL bridge, the session is up but the PC's connect to internet very slow.Please helpRegardsWilber Jimenez