Routing

Greetings,We recently migrated our edge routers to 2 seperate BGP connections to 2 seperate ISP's. Our routers are running firewall feature set.While we were going throught the issues with the ISP's we had an IP Inspect ftp statement on the inside in...

hello friends,please tell me, if i use same bgp AS number for all branch locations then what will be routing issues, i will get?

MPLS TE there are two path creation using MPLS TE 1. Explicit Path , 2. Dynamic Path.If I configure the Explicit path, It depend on the IGP?, Am I configure the RSVP to configexplicit path?In my throught, When I using Dynamic path, I must enable the ...

Hi, I am facing an strange problem. I am using cisco 2621XM router. Router fast ethernet 0/0 is able to ping its ip itself but not ping LAN network users ip on the same subnet & vise-versa. Port status is showing up when network cable is plugged and ...

I m having one 2811 Cisco router for internet connection. There is a firewall between router & Lan. Firewall & Router are connected via public IP. NAT is done on Firewall which is hiding my whole lan behind one public ip(i.e. ip on firewall interface...

WHat is EIGRP ID? Is it something like ROuter ID on OSPF? How this parameter can be used? thanks.

Why EIGRP summarizes only 10.X.X.X and 172.16.X.X ? What about 192.168.X.X isn't it the same type of address?

Hi AllI have the following Wireless Router Cisco Aironet 1240AG and I have a SONY VIO N320-E/W Laptop.It shows me under the available wireless networks and when I try to connect to it it fails and after diagonizing the problem I get the following mes...

I have a site that has a single MPLS link to it,I have an ASA firewall out there connected to a DSL internet connection. My question is where can I find a good guide to help me configure routing my router or switch to use the ASA VPN tunnel back to ...

For a mistake I've forgot a non-existent inbound route-map applied to a BGP neighbor and this router has not been receiving any advertisements from this neighbor.So I need to make sure this issue is caused by the non-existent route-map or it could be...

Hi,We have a site that is connected through fiber to the main office, we would like to create a backup link for a group of user (on a specific switch) to be able to connect to the main office through a T1 line if the fiber was accidentally damaged. W...

I have a WS-C6513 running cat6000-up2cvk8.8-4-2.bin and a WS-X6516-GBIC card module...is there a command that I can use in CAT os to shut this line card down before I remove it? or do I just pull it and hope for the best?Greatly appreciate the help!...