Routing

How do I log login failures to my syslog server? I've got traps set up for notifications (6), but I'm not seeing failures when I try to log in. Is there something I need to do in the router, or can it even be done?Thanks!John

I have a 2821 router and is trying to configure it. the problem is, whenever i reboot the router, it starts with the setup dialog and no startuo-config file on flaskOf course I save before rebooting.Please help

Hey guys!! Can someone one here point me to a doc or send me a config example of a c880 on DSL or cable modem? I would totally like to plagiarize your working config hahaha thanks in advance!

Hi,I have only one sup2 module in my switch running catos and i want to replace this with teh new sup2 module. Can someone plz give me the cisco link about the procedure to do the same.As per my knowledge here are the steps:-1) Backup the config2) sw...

hii have couple of questions:1)if i want to allocate 10mb FOR INTERneT.int f0/0traffic-shape groupe 150 10000000is this work?2)if the loopback is /32,do i need to use ip ospf network point-to-point under the lop?3)also if the lopback is /32 and i nee...

Hi,We have tow ISP links terminated on two routers WAN ports ( 1841 series). And the ethernet both the routers and the outside of the ASA are from a single subnet. ( a.b.c.0 / 24 ). Since the tow ISP's has given us a totally seperate pool of IP addr...

I ned exclude to the encription list rtp traffic. Is there any way to identify this traffic in an access-list?Thank'sMarcelo

hi, On my network i have one 3750-E and rest of the switches are 2960. I want ntp to be configured on 3750-E, but i have come to know that 3750-E cannot be a ntp master. how can i configure NTP on my domain.Thanks

Hi All,We have 7604 running with c7600s72033-advipservicesk9-mz.122-33.SRB3.bin. 7604 is running multilink bundling multiple E1's to other routers. We are running OSPF and MPLS over the multilink. The problem we are facing is if any one of the indivi...

Dear sir,I m looking for a Load Balancing Router with 4 WAN Ports(rj45) and 1 LAN port . I need to merge Four 1MBPS lines and i need output speed as 4MBPS . plz suggest me which mode is better.srini

Dear All,i need some help on enabling cisco PIX snmp. I have use the following commands but nothing is working :snmp-server host outside x.x.x.xsnmp-server host inside x.x.x.xno snmp-server locationno snmp-server contactsnmp-server community privates...

Is it needed on both IBGP routers?In my lab, I only set it on one IBGP router. On the other one, I only set the neighbor command. And I got a normal BGP peering establishment.