Routing

I have 2 sites:North PlantSouth PlantThese locations are only 1.5 miles apart and are connected via a point to point T1 as well as a 802.11G wireless bridge for redundancy. The bridge and point to point T1 are routed connections via my 2811 routers t...

Do any of the mainline IOS versions support OER? Feature navigator seems to indicate that 12.4(21) supports it. Is this true? We are wanting to implement OER on some 3845s. If we can use a mainline version we won't have to upgrade memory or flash. I...

Hi,I was just wondering how I can set up a home lab to work with a fram relay setup?I have a few routers with WIC-T1 cards and a couple of switches, that I'm using for my other labs, could I use these or do I need some extra equipment?Thanks

A customer of us have a Cisco 1803 Router. Behind the Router he have 3 networks. The customer ask to us if it is possible to limit the wan bandwith per network. I have search on the internet but i can't if it is possible can someone tell me if it is ...

Hi.I am having two Cisco router 1841 router having MPLS connectivity and 1721 router having DLS internet. This two routers are connected back to back please see the attachment for connectivity. From internet router I am able to ping google without is...

hi, what command can i use to check on the bandwidth utilization of a MLPPP link on a Cisco 3825 router.thanks.

I have a mesh network and direct Internet access comming from my ISP using dot1q vlans over an ethernet interface. I have an internal interface and a DMZ interface(for the Direct Internet Access). How can I prevent the DIA interface from talking to t...

Hi gurus,Im having these logs on my 12416/PRP. I already reboot the router and i have 2 power supply installed and still i see these logs. Another thing, my 3ge port are encountering many crc errors, does this in any how connected to these error?tia....

I have an ASA and would like to load balance between 2 service providers.I have 1 metro e link and 1 dsl between seperate providers. Is there some way to load balance between the 2 on the ASA.

Hello, From an ABR, i have RIP and OSPF running but unfortunately my "show ip route" could not give either of routes to other paths as required. Not showing up at all. Yet, my debug ip rip and debug ip ospf adj and event reveals no indications f...

I am installing a 2nd core switch and will be running hsrp between them. Currently one of my routing instances is for an IP VRF - it is calledip vrf myers rd 64576:1For the 2nd switch would I have this as ip vrf myers rd 64576:2 ??Or would it still b...

Hi, I have a Cisco 878 Router and have been asked to open ports 8585 and 8119. I have a web interface that does not show this option and I am new to telnet. Can anybody please give me some information on how to do this.Many thanks.