Routing

Dear All,I have a query regarding Auto-RP. As per my understanding we must configure sparse-dense mode on interfaces in case of Auto RP and if we don't want to configure Sparse-mode only then we have another option of configuring Auto-RP Listner so t...

Hi,I have 2 windows domains connected via site-to-site VPN. Both sites are using ios router 1811. Each site has a MS-exchange server. They need to exchange mails via esmtp. But the ip inspect smtp has dropped pkt.I have a link from microsoft explaini...

The customer router has a two ethernet connections to two routers with same ISP. All three run in same AS. The connecitivty is via BGP nothing else. The customer router is receiving a default route from both ISP routers. It is like a backup. One rout...

hello,is cisco 2811 supported on the netflow/nde config?thanks.

Hi,What is the use of getting an AS number from RIPE ( www.ripe.net )

Hi Guys,Do you have any software where i can view the traffic realtime, so as to see if anything changes during my configuration. I saw someone using this using SNMP.tnx

Hi Fellow Networkers,I was trying to block a BGP route with incomplete origin code(?) but got no luck.i tried route-map but there is no match statement for origin code, i also tried regular expression but still it didn,t work...Routers are connected ...

Hello,I'm starting a new thread, as the last one died out without resolve.I have Centurytel DSL service and the modem is in bridge mode, so the PPPoE login session gets passed through to the router. They assign us DHCP addresses (even for static - s...

Hi all. I have a cisco pix 515e where the internal ip is 192.168.1.254 and dmz ip is 192.168.2.254. I have a router which connects 192.168.1.0/24 subnet with the ip 192.168.1.253 and connects to 192.168.3.0/24 subnet. There is a server on my dmz with...

HI All,Not sure if this is right here, but I have a 5510 which is doing a l2l vpn tunnel and it is the default gateway for the lan.Now , we have added 2 MPLS routers with the inside interfaces into the lan network.They are configured in HSRP mode , a...

Hello -I have a private network behind a Cisco 2611XM router that I want to limit access to only 2 specific IP addreses. Currently I have ACLs setup to do this but I would now like to NAT to those two IPs.I would like to do this:outside IP: 10.1.1....

I'm in the process of building a config to multihome my organization to AS4323 and AS7018. I'm looking for tips and config examples to prevent transit to our routers between the two provider AS's. Can anyone share any specific examples using regular ...

I am having an issue with a MLPPP point to point bundle with two VWIC-2MTF-T1-DI (4 t1's) and one of the VWICS have errors (CRC, slips, etc) on both ports,(the other pair vwic is clean) I guess I should mention that a hardware loopback test failed; d...