Routing

HiI've been reading a lot of the posts regarding multihomed hw discussions both on mynetpro and other resources but there are a few things that I don't quite understand. I will start with describing our planned solution.Two BGP routers will each peer...

Dear All Expert,Could you let me know How can i change ip address or every thing on CP-7961G?Note: CP-7961G i connect to Cisco witch 3560.Best Regards, Rechard

This is probably very simple, but is there a way to stop a trace in progress as opposed to waiting for all 30 hops to be tried (and timed out?). I know that there are two "adjacent" routers, connected via tunnels, but when I trace to interfaces "ins...

Hi,We are using single router two different ISP,1 route Broad band line and second router is Leased line.Weather 1841 router supports autofailover ? The concept is one ISP link fails another should take up.Please let me know the sample configuration.

There is my simple network on the picture. I've also attached some show and debug commands.Line protocol down at the DTE end, and line protocol up at the DCE end. LMI types agree with each other. Debug frame-relay lmi at the DCE end gives following l...

Hi,We have 2 serial T1 AT&T links configured for MUltilink. The site was working fine till now. No changes done on the router.Now we are unable to reach the router. Got the circuit tested by at&t and turned out to be clean. Dailed into the router and...

Hi Guys,Can some one please explain me the concept of using this.ThanksMahmood

Multicast feed when delivered to trunk interface is it going to have multiple copies of the same traffic.I mean bandwidth will be multiplied based on number of vlans.

I have a scenario that I have to use both static nat and pat simultaneously on one interface. If this is possible please provide me the solution.Regards,Shahzad Iqbal

I would like to establish if a 2811 has the ability to manage and route traffic via 2 connections.We currently host a number of hosts in a datacentre and the defualt route is provided via an ethernet connection. We would now like to include a second ...

Hi All, I'm configuring an access server but faced with the following problem.R1(config)#ip host r1 2001 201.201.1.1R1(config)#ip host r2 2002 201.201.1.1R1(config)#ip host r3 2003 201.201.1.1R1(config)#ip host r4 2004 201.201.1.1R1(config)#ip ...

Good Morning. I hope someone can help me because I am at my wits ends.On one of my WAN links I am experiencing a most unusual problem.The campus is served by a Cisco router and a T1 that accesses the internet through my NOC just fine. However when ...